Manual Panasonic DMR-ES35V (page 59 of 80) (English)

3294

Zoom out

Zoom in

1/80

RQTV0134

Messages

On the unit’s display Page

On the TV Page

H, F

(“” stands for a number.)

≥An error has occurred. The number following “H” or “F” depends on the status of the unit. Check the

items in the “Error messages” section and the “Troubleshooting guide”. If the service number still

does not disappear after the check, follow the Reset procedure described below.

Reset procedure: (“The unit is on but cannot be operated.” l 62)

≥If the service numbers fail to clear, note the service numbers and contact a qualified service person.

–

SET 

(“” stands for a number.)

≥The remote control and main unit are using different codes. Change the code on the remote control. 19

HARD ERR ≥If there is no change after turning the unit on and off, consult the dealer where the unit was

purchased.

–

NoREAD ≥The disc is dirty or badly scratched. The unit cannot record, play, or edit.

≥You have used a lens cleaner and it has finished. Press [<, OPEN/CLOSE] to eject the disc.

6, 9

PLEASE WAIT

(“PLEASE” and “WAIT” are

alternately displayed.)

≥Displayed when the unit is started. This is not a malfunction.

≥The unit is carrying out its recovery process. You cannot operate the unit while “PLEASE WAIT” is

displayed.

–

PROG FULL

(“PROG” and “FULL” are

alternately displayed.)

≥There are already 16 scheduled recording programs. Delete unnecessary scheduled recording

programs.

UNSUPPORT

(“UNSUP” and “PORT” are

alternately displayed.)

≥You have inserted a disc the unit cannot play or record on. 7

UNFORMAT

(“UNFOR” and “MAT” are

alternately displayed.)

≥You have inserted a new DVD-RW/+R/+R DL/+RW or a DVD-RAM/DVD-RW (DVD-Video format)

recorded on other equipment.

U59 ≥The unit is very warm.

The unit switches to standby for safety reasons. Wait for about 30 minutes until the message

disappears.

Select a position with good ventilation when installing the unit. Do not block the cooling fan on the

rear of the unit.

–

U61 ≥There was a power failure or the AC plug was disconnected while the unit was on. The unit is

carrying out its recovery process. This process restores the unit to normal operation. The unit is not

broken. Wait until the message disappears.

–

U88 ≥There was something unusual detected with the disc while recording, playing or transferring

(copying), there was a power failure or the AC plug was disconnected while the unit was on. The unit

is carrying out its recovery process. This process restores the unit to normal operation. The unit is not

broken. Wait until the message disappears.

U99 ≥The unit fails to operate properly. Press [Í/I, POWER] on the main unit to switch the unit to standby.

Now press [Í/I, POWER] on the main unit again to turn the unit on.

–

Cannot finish recording

completely.

≥The program was copy-protected.

≥The disc may be full.

≥There are already 99 recorded titles ([+R] [+R]DL] [+RW] 49 recorded titles).

–

Cannot play. ≥You inserted an incompatible disc (Discs recorded in PAL video, etc.). –

Cannot record on the disc. ≥The disc may be dirty or scratched. 9

Unable to format.

Please check the disc.

Cannot record. Disc is full. ≥Create space by erasing any unwanted titles. [RAM] [-RW‹V›] [+RW]

[Even if you erase recorded content from the DVD-R or +R, there is no increase in disc space.

Available

recording space on a DVD-RW (DVD-Video format) or +RW increases when the last recorded title is

deleted. (The recording space may increase slightly when other titles are deleted.)]

≥Use a new disc.

38, 52,

–

Cannot record. The number

of titles has exceeded the

maximum limit.

Error has occurred. Please

press ENTER.

≥Press [ENTER] to start recovery process. You cannot operate the unit while it is recovering

(“SELF CHECK” appears on the unit’s display).

–

No disc ≥You haven’t inserted a disc. Correctly insert a disc that the unit can play.

≥The disc is upside down. If it is a single-sided disc, insert it so the label is facing up.

6, 9, 22

No VHS cassette ≥A video cassette is not inserted when recording programs. Insert a video cassette with an accidental

erasure prevention tab.

10, 22

Now recording on DVD.

To watch the VHS playback,

connect a TV to DVD/VHS

COMMON OUT terminal at the

back of the unit, and select the

appropriate input on the TV.

≥The VHS plays back while recording on DVD. You can watch the VHS playback by connect to the

DVD/VHS COMMON terminals.

Please change the disc. ≥There may be a problem with the disc. Press [<, OPEN/CLOSE] on the main unit to remove it and

check it for scratches or dirt. (The unit turns off automatically after you open the tray.)

Please set the clock. ≥The clock is not set when recording programs or setting the scheduled recording. Set the clock. 17, 20

The VHS cassette is

protected.

≥A video cassette without the accidental erasure prevention tab is inserted when recording programs.

Use a video cassette with an accidental erasure prevention tab.

This is a non-recordable disc. ≥The unit cannot record on the disc you inserted. Insert a DVD-RAM or unfinalized DVD-R,

DVD-R DL, DVD-RW (DVD-Video format), +R, +R DL or +RW.

≥You inserted an unformatted DVD-RAM, DVD-RW, +R, +R DL or +RW. Format the disc with the unit.

–

This disc is not formatted

properly.

≥The operation is prohibited by the unit, disc or cassette. 30

Changing the unit’s settings/Messages

M6VP&PC.book 59 ページ２００６年２月６日　月曜日　午後３時２０分

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic DMR-ES35V in the language / languages: English as an attachment in your email.

The manual is 4,65 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Panasonic DMR-ES35V

Panasonic DMR-ES35V User Manual - German - 60 pages

Panasonic DMR-ES35V User Manual - Dutch - 60 pages

Panasonic DMR-ES35V User Manual - French - 60 pages

Panasonic DMR-ES35V User Manual - Italian - 60 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Panasonic DMR-ES35V Manual

Product: