597960
89
Zoom out
Zoom in
Previous page
1/116
Next page
89
7
7-3-2 Error Codes
The following error codes are displayed in the display window if
an error occurs in the camera:
5. P2 Card Fully Recorded
Display window
indication
All 7 bar indicators for remaining MEDIA capacity
start blinking.
WARNING lamp
Continues to light up until an operation is
performed.
Tally lamp
Continues to blink 4 times per second until an
operation is performed.
Viewfinder The END indicator blinks.
Warning tone
Continues to beep until an operation is
performed.
Warning
description
The P2 cards are recorded to maximum capacity.
Recording/
playback operation
The recording stops.
Countermeasures
Delete the clips in the P2 card or insert a new P2
card.
8. Battery Nearly Empty
Display window
indication
One of the bars in the battery remaining indicator
starts blinking.
WARNING lamp Blinks once per second.
Tally lam p Blinks once per second.
Viewfinder The BATT LED blinks.
Warning tone Beeps 4 times per second.
Warning
description
The battery is about to run out.
Recording/
playback operation
Continues to operate.
Countermeasures Replace the battery as required.
6. Recording Error
Display window
indication
“00:00:00:11” appears in the time code display
field.
WARNING lamp
Blinks 4 times per second while recording
continues.
Tally lamp
Blinks 4 times per second while recording
continues.
Viewfinder
The REC WARNING indicator lights up.
Even after recording is stopped, this display
continues to light up until the next operation is
performed.
Warning tone
Beeps 4 times per second while recording
continues.
Warning
description
Recording signal processing error.
Recording/
playback operation
Recording stops.
Countermeasures
Restart recording. Or, turn the power OFF and
turn it ON again, before starting recording.
9. P2 Card Nearly Full
Display window
indication
One of the bars for remaining MEDIA capacity
starts blinking.
WARNING lamp
Blinks once per second while recording
continues.
Tally lam p
Blinks once per second while recording
continues.
Viewfinder The P2 card remaining capacity indicator blinks.
Warning tone
Beeps once per second while recording
continues.
Warning
description
The total remaining capacity of all the P2 cards is
two minutes or less.
Recording/
playback operation
Continues to operate.
Countermeasures
Replace the cards. If there is an empty card slot,
insert a new card.
7. Low Wireless Signal Reception
Display window
indication
No display.
WARNING lamp
Blinks 4 times per second. (During pause and
recording)
Tally lamp
Blinks 4 times per second while recording
continues.
Viewfinder
The WIRELESS RF indicator lights up while
recording continues.
Warning tone
Beeps 4 times per second while recording
continues.
Warning
description
This error indicates poor wireless audio reception
conditions.
Recording/
playback operation
Continues to operate without receiving the
wireless microphone signal.
Countermeasures
Check the microphone power supply and the
reception status of the wireless receiver.
Code No. Description
E-11 Video initialisation error
E-27 Recording control error
E-30 P2 card removal error
E-38 P2 streaming microcontroller error
E-3F Microprocessor error in the camera control circuit.
E-6F Reference signal error.
89


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic AJ-SPX 800P at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic AJ-SPX 800P in the language / languages: English as an attachment in your email.

The manual is 3,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info