99987
99
Zoom out
Zoom in
Previous page
1/134
Next page
99
6
6. SERVO
8. WIRELESS RF
WARNING lamp Flashes four times a second (during recording
and playback).
Indications on LCD
screen
SERVO display lights (during recording and
playback).
Tally lamp Flashes four times a second (during recording
and playback).
Viewfinder SERVO display lights (during recording and
playback).
Alarm Sounds four times a second (during recording
and playback).
Warning description The servo is disturbed.
VTR unit operation Operation continues but the unit may not operate
correctly.
Corrective action Turn off the power and consult your dealer. The
warning display may flash for a moment and then
disappear when tape transport commences: this
is normal and not indicative of a failure or
malfunctioning.
7. RF
WARNING lamp Flashes four times a second (during recording).
Indications on LCD
screen
RF display flashes (during standby and
recording).
Tally lamp Flashes four times a second (during recording).
Viewfinder RF display lights (during recording).
Alarm Sounds four times a second (during recording).
Warning description The video heads have become clogged. There
is a problem in the video system.
VTR unit operation The cleaning rollers are activated to clean the
heads (for a maximum of 3 seconds).
Recording continues but the signals may not be
recorded correctly.
The indications on LCD screen are retained until
the REC/PAUSE status is established. They go
off as soon as the unit transfers from the
REC/PAUSE mode to another mode.
Corrective action Clean the heads. If the signals cannot be
recorded correctly even after cleaning, consult
your dealer.
WARNING lamp Flashes four times a second (during standby and
recording).
Indications on LCD
screen
No indication
Tally lamp Flashes four times a second (during recording).
Viewfinder WIRELESS RF display lights for at least 3
seconds during recording.
Alarm Sounds four times a second (for at least 3
seconds during standby and recording).
Warning description Poor wireless signal reception.
VTR unit operation Operation continues but the signals from the
wireless microphone cannot be received.
Corrective action Check the microphones power supply and the
reception condition of the receiver.
9. BATTERY NEAR END
WARNING lamp Flashes once a second.
Indications on LCD
screen
The bar display that shows the remaining battery
charge starts flashing.
Tally lamp Flashes once a second.
Viewfinder BATT LED starts flashing.
Alarm Sounds four times a second.
Warning description The battery charge is nearly depleted.
VTR unit operation Operation continues.
Corrective action Replace the battery when it becomes necessary.
10. TAPE NEAR END
WARNING lamp Flashes once a second (during recording).
Indications on LCD
screen
The bar display that shows the remaining tape
amount starts flashing.
Tally lamp Flashes once a second (during recording).
Viewfinder
The remaining tape display starts flashing (in
the EE mode).
=
flashes for 3 seconds one minute before
the tape reaches the end.
Alarm Sounds once a second.
Warning description The tape is close to its end (about 2 minutes
remain).
VTR unit operation Operation continues.
Corrective action Replace the cassette tape when it becomes
necessary.
Chapter 6 Maintenance and inspections (continued)
11. 1394
WARNING lamp Flashes four times a second.
Indications on LCD
screen
1394 E-22 display flashes.
Tally lamp Flashes four times a second.
Viewfinder When error code 92 appears, 1394 INITIAL
ERROR display lights (during standby).
Alarm Sounds four times a second.
Warning description There is something wrong with the signals
supplied to the DVCPRO connector.
VTR unit operation Operation continues, but something is wrong with
the signals supplied to the DVCPRO connector.
Corrective action Check the IEEE 1394 cable and DVCPRO
connector connections and the settings of the
external units or menu settings, and then turn the
power off and back on.
If the warning display is not cleared, check 6-3-2
Error codes, and consult your dealer.
01.AJ-HDX900_P_E(VQT0X86)_E 06.6.22 12:53 PM ページ99
99


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic AJ-HDX900 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic AJ-HDX900 in the language / languages: English as an attachment in your email.

The manual is 2,92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info