99987
91
Zoom out
Zoom in
Previous page
1/134
Next page
91
6
6-1-3 Inspecting the VTR unit
Perform all the steps outlined in section 1. Tape travel
inspection through section 4. Earphone and speaker
inspection one after the other.
1. Tape travel inspection
1
Set the VTR SAVE/STBY switch to SAVE, and check
that the SAVE lamp inside the viewfinder lights.
2
Set the VTR SAVE/STBY switch to STBY, and check
that the SAVE lamp goes off.
3
Set the TCG switch to R-RUN.
4
Set the DISPLAY switch to CTL.
5
Press the units REC START button, and check that:
The tape reels rotate.
The figure shown on the counter display changes.
The REC lamp inside the viewfinder lights.
The RF and SERVO displays do not appear in the
display window.
6
Press the units REC START button again. Check that
the tape stops and the REC lamp inside the viewfinder
goes off.
7
Use the lens VTR button to check the same operations
as in steps 5 and 6.
8
Press the RESET button, and check that 00:00:00:00
appears on the counter display.
9
Set the LIGHT switch to ON, and check that the display
window illuminates.
10
Press the REW button, and after the tape has been
rewound for a few seconds, press the PLAY/PAUSE
button.
Check that the tape is recorded, played back and
rewound properly.
11
Press the FF button, and check that the tape is fast
forwarded properly.
2. Automatic audio level adjustment function
inspection
1
Set the AUDIO SELECT CH1 and CH2 switch to AUTO.
2
Set the AUDIO IN CH1 and CH2 switches to FRONT.
3
Point the microphone connected to the MIC IN jack at a
suitable sound source, and check that the changes in
the level displays for both CH1 and CH2 reflect the
changes in the strength of the sound.
3. Manual audio level adjustment function
inspection
1
Set the AUDIO IN CH1 and CH2 switches to FRONT.
2
Set the AUDIO SELECT CH1 and CH2 switch to MAN.
3
Turn the AUDIO LEVEL CH1 and CH2 controls.
Check that when they are turned clockwise, the level
displays increase.
4. Earphone and speaker inspection
1
Set the VTR SAVE/STBY switch to STBY.
2
Turn the MONITOR control, and check that the speaker
volume changes.
3
Connect the earphones to the PHONES jack.
Check that the sound from the speaker is muted, and
that the microphones sound is heard in the earphones.
4
Turn the MONITOR control, and check that the
earphone volume changes.
Chapter 6 Maintenance and inspections (continued)
01.AJ-HDX900_P_E(VQT0X86)_E 06.6.22 12:53 PM ページ91
91


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic AJ-HDX900 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic AJ-HDX900 in the language / languages: English as an attachment in your email.

The manual is 2,92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info