99989
129
Zoom out
Zoom in
Previous page
1/140
Next page
129
Maintenance
The water vapor in the air may form as tiny droplets
on the head drum when the unit is moved from a cold
location to a warm location or used in a very humid
place. This phenomenon is known as condensation,
and running the tape under these conditions is liable
to cause the tape to stick to the drum.
Note the following points:
O Remove the tape when the unit’s operation is to be
started in conditions where condensation may form.
O Before loading the tape, set the power switch to
ON, and check that the HUMID display is not
lighted in the display window.
<Note>
For safety reasons, the HUMID display will flash and
the drum will rotate for 80 minutes after condensation
detection is released.
During this time, the operation buttons cannot be
operated.
Check that the HUMID display
is not lighted.
Condensation
Use the AJ-CL12LP cleaning cassette if the heads
need to be cleaned. Take care to read the
instructions accompanying the cleaning tape since the
video heads may be damaged if the tape is not used
in the correct way.
Head cleaning
O Do not use thinners or any other solvent to remove
dirt.
O Use a lens cleaner available on the market to wipe
the lens.
O NEVER wipe the mirror.
If dirt or dust has found its way onto the mirror,
remove it using an air blower available on the
market.
Cleaning inside the viewfinder
Smear
This phenomenon may occur when very bright
subjects are shot.
The faster the electronic shutter speed, the more likely
that it will occur.
White blemish
This phenomenon is caused by small white spots
when dark places are shot. The lower the frame rate
or the higher the gain, the more noticeable it
becomes.
Phenomena inherent to CCD
cameras
Replacing the backup battery
The backup battery is already installed when the unit
is shipped.
When it has discharged, the “BACK UP BATT
EMPTY” display appears for 3 seconds on the
viewfinder screen when the POWER switch is set to
ON.
Moreover, the time code value of the TCG will be set
to “00:00:00:00” and the backup of the time code
value will no longer be possible: this means that the
backup battery should be replaced.
Consult with your nearest service center, and replace
the spent battery with a new battery (CR2032 or
BR2032).
Backup battery
CAUTION:
These servicing instructions are for use by qualified
service personel only. To reduce the risk of electric
shock, do not perform any servicing other than that
contained in the operaiting instructions unless you
are qualified to do so.
04. (P128-表4/140) 05.5.18 10:45 ページ129
129


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic AJ-HDC27HP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic AJ-HDC27HP in the language / languages: English as an attachment in your email.

The manual is 3,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info