597929
19
Zoom out
Zoom in
Previous page
1/42
Next page
Record mode
19
ª Recording mode
You can switch the tape recording mode.
Set to Tape Recording/Playback Mode.
1 Set [BASIC] or [ADVANCE] >> [REC SPEED] >> [SP] or
[LP].
If the LP mode is selected, the recording time will be 1.5 times
the SP mode, but some functions will be disabled.
We recommend using the SP mode for important recording.
In order to fully exhibit the performances of the LP mode, we
recommend using Panasonic cassettes marked LP mode.
It is not possible to dub audio onto image recorded in the LP
mode. (
-30-)
In the LP mode, the picture quality will not be degraded in
comparison with the SP mode, but mosaic noise may appear
on the playback image or some functions may be disabled.
Playback on other digital video equipment or on digital
video equipment without the LP mode
Playback of the image on other digital video equipment
recorded in the LP mode
Slow/frame-by-frame playback
Recording on a tape
Remove the lens cap. (-9-)
(When the camera-recorder is turned on with the lens cap fitted,
the automatic white balance adjustment may not function
properly. Please turn the camera on after removing the lens
cap.)
Set to Tape Recording Mode.
1 Press the recording start/stop button (or sub recording
start/stop button) to start recording.
2 Press the recording start/stop button (or sub recording
start/stop button) again to pause recording.
For the recording time on a tape, refer to
-11-.
Carry out a recording check (
-19-) to verify that the image is
recorded properly.
In order to find the unrecorded section, carry out the blank
search (
-19-).
ª
On-screen display in the tape recording mode
1) Recording time elapse
2) Remaining tape indication
ª
Concerning the remaining tape time indication on
the screen
The remaining tape time is indicated in minutes. (When it
reaches less than 3 minutes, the indication starts flashing.)
During a 15-second or shorter recording, the remaining tape
time indication may not be displayed or the remaining tape
time may not be displayed correctly.
In some cases, the remaining tape time indication may
display remaining tape time that is 2 to 3 minutes shorter than
the actual remaining tape time.
Check the recording
The last image recorded is played back for 2 to 3 seconds.
After checking, the camera-recorder will be set to a recording
pause.
Set to Tape Recording Mode.
1 Press the [ENTER] button during the recording pause
until the icon 1 appears.
2 Press the [4] button to select the recording check icon
[].
Blank search function
Searches for the last part of the image recorded (unused part of
the tape).
Set to Tape Recording/Playback Mode.
1 Set [BASIC] or [ADVANCE] >> [BLANK SEARCH] >>
[YES].
ª
Stopping blank search midway through
Press the [4] button to select the [] icon.
If the cassette tape has no blank part, then the camera-
recorder will stop at the end of the tape.
The camera-recorder stops at a point approx. 1 second
before the end of the last image recorded. When you start
recording at that point, the image can be recorded seamlessly
from the last image.
CAMERA
VCR
O
F
F
O
N
;
1)
2)
1
DVC20_Eng.book 19 ページ 2006年4月6日 木曜日 午前10時10分
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic AG-DVC 20p at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic AG-DVC 20p in the language / languages: English as an attachment in your email.

The manual is 3,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info