492262
34
Zoom out
Zoom in
Previous page
1/56
Next page
32
MAKING USER SETTINGS (cont.)
If you have not done so, put your set-top into “user settings mode”, as described on page 21. The
front panel displays “ASPt”.
The flow diagram on the right shows how you use the arrow, select and power buttons on your
set-top’s front panel to change the display and make the settings. See also the instructions below.
1. Press the D button until the front panel displays “rSEt” (short for restore factory settings”), as
shown right.
2. Press the R button. “YES” displays on your set-top’s front panel. (If you no longer wish to restore
the factory settings, press the L button.)
3. To restore the factory settings, press the select button.
4. The factory settings are restored. If you want to continue changing the settings, press L then see
the sections from page 21 onwards. If you have finished changing the settings, press the power
button. Your set-top will switch on with the restored settings.
NOTES
If your set-top and HDTV are connected via a HDMI cable, some HDTVs may pass information about the
required settings back to your set-top (see page 23). If you wish to restore your set-top’s settings to those
created by the HDTV, you should disconnect your set-top from the HDTV before you restore the factory
default settings. When you reconnect the HDTV to your set-top via the HDMI cable, the HDTV will pass
back the information again.
Always disconnect your set-top from the AC power supply before you connect or disconnect
any other equipment to or from its rear panel.
34


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pace TDC 776D at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pace TDC 776D in the language / languages: English as an attachment in your email.

The manual is 1,59 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info