492261
12
Zoom out
Zoom in
Previous page
1/56
Next page
10
CONNECTING THE EQUIPMENT
Your equipment should have been connected up by your installer. However, if you
need to disconnect and re-connect your equipment, please read the information on
pages 10 to 14.
On pages 12 and 13 there are two typical connection set-ups for an HDTV, VCR,
DVD player and home theater receiver.
These set-ups make efficient use of the connectors on your set-top. However,
depending on your other equipment and the connectors on it, the person who
installed your system may have chosen to connect things up differently.
Both set-ups allow stereo recording and play-back of video tapes. You hear stereo
sound from the home theater’s loudspeakers.
Although the RF cables are not absolutely necessary, we recommend that you
connect them as a back-up and so that you can use the RF bypass (but note that they
will provide only mono sound to the TV and VCR).
If you also connect an optical audio connector, as shown, it means that the home
theater receiver can take advantage of digital audio via your set-top’s optical audio
output.
WARNINGS
Do not connect your set-top (or any other
equipment such as a TV or VCR) to the AC power
supply until you have properly connected all the
other cables.
Disconnect your set-top from the AC power
supply before you disconnect any other
equipment from its rear panel.
The only way to disconnect your set-top from
the AC power supply is to remove the AC power
cord (or switch the wall socket-outlet switch, if
present, to its OFF position). Your set-top must
therefore be installed near to the AC power
socket-outlet, which should be easily accessible.
The power outlet is designed only for connection
to the AC power cord for a TV. The maximum
power it can supply is 500 watts. Do not connect
any equipment that uses more than 500 watts, or
any non-TV equipment such as a toaster or hair
dryer.
The cable input is designed for connection to a
cable network only. You must not connect any
other equipment, such as a VCR, to this input.
Any cable connected to DIGITAL AUDIO jacks
must be 75 ohm coaxial, not regular audio cable.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pace TDC 775D at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pace TDC 775D in the language / languages: English as an attachment in your email.

The manual is 1,59 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info