62846
11
Zoom out
Zoom in
Previous page
1/41
Next page
9
GETTING STARTED
INSERTING YOUR REMOTE
CONTROLS BATTERIES
Insert the two batteries into your remote control.
Make sure you insert them the correct way round,
as shown by the + and symbols in the battery
compartment.
REPLACING THE BATTERIES IN YOUR
REMOTE CONTROL
Always replace both batteries at the same time.
Please dispose of batteries in an
environmentally-friendly way.
Used alkaline batteries must never be thrown
into a re.
SWITCHING ON YOUR SETTOP
BOX
When you have connected your set-top box to
the mains supply, its indicator light, just below the
Standby button (S), will light up.
If your set-top box is in standby, the light will be red;
if your set-top box is out of standby, the light will
be blue.
If the indicator light is red, switch on your TV, then
press the Standby button (S) on the front panel of
your set-top box.
Whenever you are not using your set-top box, you
should put it into standby by pressing the Standby
button (S).
SWITCHON CHANNEL SETTING
The factory setting for your set-top box is for it to
always tune to the last-viewed channel when you
bring it out of standby. You can change this setting,
so that your set-top box tunes to a specic channel
instead (see page 31).
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pace DS 810 XE at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pace DS 810 XE in the language / languages: English as an attachment in your email.

The manual is 2,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info