62846
5
Zoom out
Zoom in
Previous page
1/41
Next page
3
IMPORTANT
USING EQUIPMENT SAFELY
Your set-top box has been manufactured to meet
international safety standards, but you must take
care to operate it safely.
It is important that you read these safety
instructions.
WARNING: Remember that contact with AC
mains can be lethal or can cause severe electric
shock. To avoid the risk of electric shock:
Never remove the top cover from your set-top
box as there are high-voltage live parts inside.
There are no user-serviceable parts inside your
set-top box.
On the rear panel of your set-top box there is a
tamper-evident label that states Warranty void
if broken or removed’.
Make sure all electrical connections are properly
made.
Do not connect any equipment to the mains
supply until you have properly connected all
the other leads.
Disconnect your set-top box from the mains
supply (by disconnecting its mains lead from
the mains socket on the wall) before you
disconnect any other equipment from its rear
panel.
Never push anything into holes, slots or other
openings in the case (except a CI module
into the slot provided, and only when you are
requested to do so).
CAUTION:
Do not use or store your set-top box in hot,
cold, damp or dusty places.
Do not block the ventilation holes of your
set-top box. Leave a gap of at least 5 cm above
and around it to allow for adequate ventilation.
Never stand it on soft furnishings.
Do not put anything on your set-top box which
might drip or spill into it. Never stand objects
lled with liquids, such as vases, on top of your
set-top box.
Do not place your set-top box in an
unventilated cabinet or on top of a unit which
emits heat (e.g. a VCR).
Never place naked ame sources, such as
lighted candles, on top of your set-top box.
CONNECTING TO THE MAINS
SUPPLY
Your set-top box operates with a 230 V AC, 50 Hz
mains supply.
Do not connect your set-top box to any supply
other than this.
The supplied mains lead has a 2-way connector
at one end and a mains plug at the other. You
should always insert the 2-way connector into
your set-top box before you insert the plug into
the mains supply.
The only way to disconnect your set-top box
from the mains is to remove the mains lead.
Your set-top box must therefore be installed
near to the mains socket-outlet, which should
be easily accessible.
If you are in any doubt about the mains lead,
its plug or its connection, consult a competent
electrician.
Please follow the instructions in the following
sections, which guide you through connecting
and setting it up.
See also pages 14 and 15, which describe your
set-top box’s remote control.
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pace DS 810 XE at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pace DS 810 XE in the language / languages: English as an attachment in your email.

The manual is 2,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info