779805
14
Zoom out
Zoom in
Previous page
1/32
Next page
Starting procedure for a warm engine. Move the fuel tap to the ON position, Move the throttle lever to
mid position and the choke lever to the RUN position. Turn the engine switch ON. SLOWLY pull the
recoil starter handle until you feel a resistance then pull firmly with a smooth steady motion to start.
Pull the handle straight out to avoid excessive rope wear from the
starter rope guide. DO NOT let go of the recoil starter handle instead allow it to return gently.
NOTE: To extend the life of the recoil starting rope periodically check its condition. If the rope is frayed,
have it replaced immediately.
3.3. During use.
3.3.1. Under long, continuous-run operating conditions, be prepared to :
3.3.1.1. Check the fuel on a regular basis. DO NOT re-fuel when the engine is running or HOT.
3.3.1.2. Check engine oil level each time you refuel. See engine owner’s manual for more details.
3.3.1.3. Check pump oil level before each use.
3.2. Starting procedure. from warm i.e. machine has been run recently.
Page 14
First edition - April 2017
The water must be turned on prior to starting the washer, pull the spray trigger to ensure water is
moving the through the lines and out the nozzle without any leaks before starting the unit. Failure to
do this will result in damage to the seals which will not be covered under warranty
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for P1PE P72800A at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of P1PE P72800A in the language / languages: English as an attachment in your email.

The manual is 9.45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info