547420
23
Zoom out
Zoom in
Previous page
1/32
Next page
22
Restarting the system
As is the case for any computer-controlled equipment, also with your
Oyster Vision a “crash” of the software could occur. Causes for this
might be external influences, e.g. strong electromagnetic disturbances, or
also software bugs that had not yet been discovered so far.
If you are of the opinion that your Oyster Vision reacts incorrectly or
does not react at all to your control inputs any more, then you should
restart the microprocessor. You can do this in different ways.
- If the fuse in the set of cables is easily accessible for you, pull this
fuse and then insert it again into the holder after a few seconds.
- If the fuse is inaccessible, plug off the Western plug on the right
side of the operating control. To do this, you must from the rear
press the plastic clips against the body of the plug and then pull the
plug from the device. Now simultaneously press the two keys
and at the operating control; keep them firmly pressed and
insert the Western plug again. Now you can release the two keys.
With both described cases, your Oyster Vision will internally perform a
reset. If the system had been extended, then it will first retract. After the
reset, the system will be in standby mode and can again be switched on
as usual with the key
.
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Oyster Oyster Vision II at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Oyster Oyster Vision II in the language / languages: English as an attachment in your email.

The manual is 0,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Oyster Oyster Vision II

Oyster Oyster Vision II User Manual - German - 30 pages

Oyster Oyster Vision II User Manual - Dutch - 8 pages

Oyster Oyster Vision II User Manual - Dutch - 18 pages

Oyster Oyster Vision II Installation Guide - Dutch - 12 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info