606567
4
Zoom out
Zoom in
Previous page
1/42
Next page
E: Trial t the Oxford HotGrips
1. Always “dry fi t” the grip to the bar fi rst, to ensure that the grip is a snug fi t before using the adhesive.
2. The HotGrips have a unique internal tube that can expand to fi t over the handlebar.
3. This makes them easier to fi t over handlebars that have inconsistent diameter bars due to
manufacturing tolerances.
4. If the grips are too tight to slide on with only gentle effort, do not force them on
or damage may occur. Check the dimensions of the handlebars again and adjust as necessary.
5. When sliding the grips onto the handlebars it is possible to twist them into place until they reach the
correct fi nished position.
F: Positioning on handlebars:
1. Position the grips so that the wires do not foul against the brake / clutch levers.
The throttle grip should rotate freely without obstruction and without stretching or pinching the wires.
The ideal fi tment position of the grips can vary from bike to bike. We nd that an
ideal position can be one whereby the wires of the grips sit just below the brake and throttle levers.
This position allows the Hotgrip wiring to be neatly attached to the clutch/brake cables and usually
prevents the wires from being strained.
However some people prefer the wire of the grips to sit a safe clearance above the brake and clutch
levers so that the wire exits forward and relatively horizontal. When the throttle is opened the wire will
then raise upwards and away from the brake lever.
2. Before removing the grips for the fi nal fi tting procedure, it is important to connect the electrical wiring
harness to the battery and the grips. With the motorcycle engine running the grips can be switched on
to make sure that the grips operate as expected. Failure to do so may invalidate the warranty.
G: Final fi tting of grips
1. Use the Super glue provided. It has been proven for this application and we cannot guarantee the
suitability of an alternative.
2. Warning: The Superglue will bond skin and eyes in seconds. Keep out of reach of children.
IT IS VERY IMPORTANT TO FIT THE GRIP IMMEDIATELY AND WITHOUT DELAY BECAUSE THE
SUPERGLUE PROVIDED WILL BOND THE HOTGRIPS TO THE BARS VERY QUICKLY. THIS IS
PARTICULARLY RELEVANT WITH THE THROTTLE SLEEVE AND HOTGRIPS
Don’t let the glue drip onto paintwork. Shield paintwork appropriately.
Throttle open Throttle closed
3 Oxford Hotgrips instructions v.7 switch - 10/12/08
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Oxford OF693 HotGrips at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Oxford OF693 HotGrips in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 0,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Oxford OF693 HotGrips

Oxford OF693 HotGrips Usermanual and installation guide - Dutch - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info