606569
3
Zoom out
Zoom in
Previous page
1/7
Next page
Oxford Hotgrips instructions v.8 switch - 09/07/12
3
Tools needed:
A course and ne le for smoothing the throttle slider tube
Glass paper for cleaning the handlebars
Cable snippers or pliers
Standard motorcycle tools to remove the seat, fairing panels and battery connections
C: Fitting and Wiring Instructions for Motorcycles
Your Oxford HotGrips are designed as a replacement for the handle bar grips already fitted to the motorcycle.
Hotgrips will t onto most motorcycles that use 22mm or 7/8” Ø handlebars. The grip has an open end to allow for
the bar end weight to be refitted without the need to trim the grip. If the end of the Hotgrip does need to be trimmed
to ensure that a bar-end weight can be tted without fouling the Hotgrips, then it is advisable to trim up-to the point
shown in the diagram below. This ensures that the heating elements do not get cut.
The left and right grip are different sizes:
One is designed to t over the left handlebar and has an internal diameter of approximately 22mm.
The other ts over the throttle slider on the right handlebar and has a diameter of approximately 25mm.
D: Fitting Procedure
1. Remove the existing handlebar grips.
2. Clean the left handlebar ensuring that the bars are smooth and free of glue and residue.
3. The bar should measure a consistent 22mm diameter.
4. When the right grip is removed there is a nylon throttle slider underneath. This may need to be removed and any
raised areas smoothed off to ensure that the diameter is a consistent 25.6mm.
This often involves filing off the raised ridges that were formed on the throttle slider.
Trim length here (picture below)
E: Trial fit the Oxford HotGrips
1. Always “dry t” the grip to the bar rst, to ensure that the grip is a snug t before using the adhesive.
2. The HotGrips have a unique internal tube that can expand to t over the handlebar.
3. This makes them easier to t over handlebars that have inconsistent diameter bars due to manufacturing
tolerances.
4. If the grips are too tight to slide on with only gentle effort, do not force them on or damage may occur. Check the
dimensions of the handlebars again and adjust as necessary.
5. If the HotGrips do not slide on easily, check if there is any excess rubber on the inside of the grip which may have
seeped through the expansion slot during manufacturing. If so, use a long file and gently remove the excess
rubber with the edge of the file.
6. When sliding the grips onto the handlebars it is possible to twist them into place until they reach the correct
finished position.
Trim lengths
Trim lengths Trim lengths
OF690 Adventure OF691 Touring OF692 Sports
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Oxford OF690 HotGrips at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Oxford OF690 HotGrips in the language / languages: English as an attachment in your email.

The manual is 2,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Oxford OF690 HotGrips

Oxford OF690 HotGrips User Manual - English, German, French, Italian, Spanish - 42 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info