650001
20
Zoom out
Zoom in
Previous page
1/43
Next page
19
high output levels.
3. EXTERNAL SPEAKER: The External Speaker Jack is used for remote receiver
monitoring. The external speaker should have 8 ohms impedance and be rated to handle
at least 4.0 watts. When the external speaker is plugged in, the internal speaker is
automatically disconnected.
4. POWER: These wires supply power to the CB radio. See page 5 for installation.
Operating Procedure to Receive
2. Be sure that the power, antenna and microphone are properly connected before
proceeding further. The CB/PA switch should be in the CB mode. The Channel 9/NOR
Switch should be in the NOR mode.
2. Turn the radio ON by rotating the VOLUME CONTROL clockwise.
3. Rotate SQUELCH CONTROL counterclockwise until incoming signal is heard.
4. Turn the CHANNEL SELECTOR KNOB to select the desired operating channel.
5. Set the VOLUME CONTROL to a comfortable listening level.
Listen to the background noise from the speaker. Turn the SQUELCH CONTROL slowly
clockwise until the noise JUST disappears (no signal should be present). Leave the control at
this setting. The squelch is now properly adjusted. The receiver will remain quiet until a
signal is actually received. Do not advance the control too far, or some of the weaker signals
will not be heard.
Operating Procedure to Transmit
1. Select the desired channel.
2. Press-to-Talk Switch. The receiver and transmitter are controlled by the press-to-talk
switch on the microphone. Press the switch and the transmitter is activated; release
switch to receive. When transmitting, (on a clear channel), hold the microphone two
inches from the mouth and speak in a clearly normal voice.
Be sure the antenna is properly connected to the radio before transmitting.
Prolonged transmitting without an antenna, or a poorly matched antenna,
could cause damage to the transmitter.
Operating Procedure for Public Address
1. Connect a PA speaker to the PA jack provided on the rear panel.
2. Set the CB/PA switch to the PA position.
3. Depress the push-to-talk switch on the microphone and speak in a normal voice.
4. Adjust the volume of the PA speaker using the Volume control on the front panel.
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Overmax CB-501B at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Overmax CB-501B in the language / languages: English, Polish as an attachment in your email.

The manual is 1,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info