01 / 2010
C2000 Page 155
Operation
To adjust the back angle of a Recaro® seat model, use the
turning handle on the right or left side of the backrest.
A release handle is used to fold down the backrest. It is lo-
cated on the side of the backrest. By pulling the release
handle upward, the backrest can be folded down to the front.
If the backrest is brought into its initial position, it automati-
cally locks in place. Verify that the backrest is securely locked
in place every time it has been unlocked.
The Recaro® seat can be equipped with an electric back
angle adjustment. The control in the “additional function”
mode is used to control this function (see Section 6.3.5). With
the Recaro® LT backrest, the lateral guide in the lumbar sec-
tion can be individually adjusted by turning the hand wheel.
Turning the wheel to the front brings the two lateral guides
closer to each other evenly. Turning the wheel to the rear
adjusts the two lateral guides away from each other.
Seatbottom
The type X and W seat bottoms have an extendable padding
section at the front. The lever used to adjust the padding
section is located below the seat bottom. Pull the lever up to
shift the padding section into the desired position. The padding
section locks in place as soon as the adjustment lever is re-
leased. The adjustment lever must audibly lock in place and
return to its initial position.
Headrest
The height setting of the headrest can be changed, and the
inclination is adjustable.
A second person is needed to remove the headrest. The
pressure points must be detected under the cover by feel and
be pressed simultaneously. Now the second person can pull
the headrest up and out.
180
10
1 0
Fig.28 Illustrationofpressurepoints
