589232

Oregon Scientific EMR899 Manual

5
Zoom out
Zoom in
Previous page
1/12
Next page
4
GB
Note that once a channel is assigned to a remote unit, you can only
change it by removing the batteries or resetting the unit.
BATTERY INSTALLATION: MAIN UNIT
The main unit uses two AA-size batteries. To install them,
1. Slide open the battery compartment door.
2. Insert the batteries strictly according to the polarities shown
therein.
3. Replace the battery compartment door.
Replace the batteries when the low-battery indicator of the indoors
temperature lights up. (Repeat the steps described in section
“BEFORE YOU BEGIN”)
GETTING STARTED
Once batteries are in place for the remote units, they will start
transmitting temperature readings at 30-second intervals.
The main unit will also start searching for signals for about a minute
once batteries are installed. Upon successful reception, the indi-
vidual channel temperatures will be displayed on the top line and the
indoors temperature on the bottom line. The main unit will automati-
cally update its readings at about 30-second intervals.
If no signals are received, blanks “
” will be displayed and the
kinetic wave icon will show “
CHANNEL
”. Press CHANNEL and MEM
simultaneously to enforce another search for about 30 seconds. This
is useful in synchronizing the transmission and reception of the
remote and main units.
Repeat this step whenever you find discrepancies between the reading
shown on the main unit and that on the respective remote unit.
HOW TO CHECK REMOTE AND
INDOOR TEMPERATURES
The indoors temperature is shown on the bottom line of the display.
As for the remote sites or channels, press CHANNEL to go from one
channel to another. The kinetic wave display on the channel number
indicates the reception of that particular channel is in good order.
If no readings are received from one particular channel for more than
two minutes, blanks “
” will be displayed until further read-
ings are successfully searched. Check the remote unit is sound and
secure. You can wait for a little while or press CHANNEL and MEM
simultaneously to enforce an immediate search. Of course no reading
will be shown if no remote unit is assigned to that channel.
The temperature trend indicator on the screen shows the trend of
readings collected at that particular remote site. Three trends, rising,
steady and falling, will be shown.
HI
LO
TEMP
TREND
CHANNEL
IN
EMR899-English R2 R OP 8/27/04, 5:46 PM4
Black
… 5 …


Need help? Post your question in this forum.

Forumrules
1

Forum

oregon-scientific-emr899

Reset search

  • What is the price of this emr899 and can I buy it in Canada or have it shipped to me Submitted on 11-5-2022 at 20:12

    Reply Report abuse

  • what is the price and can I get this in Canada and have it delivered to me Submitted on 11-5-2022 at 20:10

    Reply Report abuse

  • re: TEMPMINDER model 3: EMR899
    My remote unit [outside] does not record the correct temperature. I have installed new batteries
    and followed the recommended start up procedures.
    Any suggestions?
    Enzo
    enzomorson@gmail.com Submitted on 9-9-2020 at 17:26

    Reply Report abuse

  • My remote unit [re model No.: EMR 899] is not recording the correct temperature. Off by 10 degrees C or more all the time.
    Any suggestions?
    enzomorson@gmail.com Submitted on 9-9-2020 at 17:23

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Oregon Scientific EMR899 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Oregon Scientific EMR899 in the language / languages: English as an attachment in your email.

The manual is 1,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Oregon Scientific EMR899

Oregon Scientific EMR899 User Manual - German - 11 pages

Oregon Scientific EMR899 User Manual - Dutch - 9 pages

Oregon Scientific EMR899 User Manual - French - 10 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info