Powering On the Projector
1. Remove the lens cap.
2. Securely connect the power cord and signal cable. When con-
nected, the Power LED will turn red.
3. Turn on the lamp by pressing “ ” button on the side of the projec-
tor or on the remote control. The Power LED will ash blue.
The startup screen will display in approximately 30 seconds. The
rst time you use the projector, you can select your preferred lan-
guage from quick menu after the startup screen display.
4. Turn on your source that you want to display on the screen (com-
puter, notebook, video player, etc). The projector will detect the
source automatically and will display on the screen. If not, push
menu button and go to “SETUP”. Make sure that the “Source
Lock” has been set to “Off”.
If you connected multiple sources at the same time, press the
“Source” key on the remote control to switch between inputs.
Turn on the
projector rst and
then select the
signal sources.
1
