EN-60
Troubleshooting
Refer to the symptoms and measures listed below before sending the projec-
tor for repairs. If the problem persists, contact your local reseller or service
center. Please refer to "LED Indicator Messages" as well.
Start-up
If no lights turn on:
Be sure that the power cord is securely connected to the projector and the
other end
is plugged into an outlet with power.
Press the power button again.
Unplug the power cord and wait for a short while, then plug it in and press
the power
button again.
Image
If the searching source is displayed:
Press
SOURCE
on the projector or
Source
on the remote control
to select
an active input source.
Be sure the external source is turned on and connected.
For a computer connection, ensure your notebook computer’s external
video port is
turned on. Refer to the computer manual.
If the image is out of focus:
While displaying the on-screen menu, adjust the focus ring. (The image
size should
not change; if it does, you are adjusting the zoom, not the
focus.)
Check the projection lens to see if it needs cleaning.
If the image is flickering or unstable for a computer connection:
Press
“
Menu
”
, go to IMAGE > Advanced > Signal and adjust Phase or
Frequency.
Remote control
If the remote control does not operate:
Be sure nothing is blocking the remote control receiver on the front of the
projector. Use the remote control within the effective range.
Aim the remote control at the screen or at the front of the projector.
Move the remote control so it is more directly in front of the projector and
not as far to the side.
