Please follow all warnings, precautions and mainte-
nance as recommended in this user’s guide.
When the lamp
reaches the end
of its life, the pro-
jector will not turn
back on until the
lamp module has
been replaced. To
replace the lamp,
follow the proce-
dures listed under
“Replacing the
Lamp” section.
▀■ Warning-
Do not look into the projector’s lens when the
lamp is on. The bright light may hurt your eyes.
▀■ Warning-
To reduce the risk of re or electric shock, do
not expose this projector to rain or moisture.
▀■ Warning-
Please do not open or disassemble the projec-
tor as this may cause electric shock.
▀■ Warning-
When replacing the lamp, please allow the unit
to cool down.
▀■ Warning-
This projector will detect the life of the lamp
itself. Please be sure to change the lamp when
it shows warning messages.
▀■ Warning-
Reset the “Lamp Reset” function from the on-
screen display “System|Lamp Setting” menu
after replacing the lamp module.
▀■ Warning-
When switching the projector off, please ensure
the cooling cycle has been completed before
disconnecting power. Allow 90 seconds for the
projector to cool down.
▀■ Warning-
Do not use lens cap when projector is in opera-
tion.
▀■ Warning-
When the lamp is approaching to the end of
its life time, the message “Replacement sug-
gested” will show on the screen. Please contact
your local reseller or service center to change
the lamp as soon as possible.
