215969
60
Zoom out
Zoom in
Previous page
1/72
Next page
English
60
Replacing the Lamp
The projection lamp should be replaced when it burns out. It should
only be replaced with a certied replacement part, which you can
order from your local dealer.
Important:
4
The lamp contains a certain amount of mercury and should be
disposed of according to local ordinance regulations.
4
Avoid touching the glass surface of the new lamp, doing so may
shorten its operation life.
Warning:
4
Be sure to turn off and unplug the projector at least an hour before
replacing the lamp. Failure to do so could result in a severe burn.
1. Loosen the two captive screws on the lamp compartment cover.
2. Remove the lamp compartment cover.
3. Remove the two screws from the lamp module.
4. Lift the module handle up and pull rmly on the module handle to
remove the lamp module.
5. Insert the replacement lamp and push down rmly. Tighten the
captive screws to hold the lamp in place.
6. Replace the lamp compartment lid and tighten the captive screws.
After replacing the lamp, the lamp hours counter must be reset. See
page 47 for more information.
Appendices
60


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Optoma ex532 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Optoma ex532 in the language / languages: English as an attachment in your email.

The manual is 12,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info