721782
70
Zoom out
Zoom in
Previous page
1/79
Next page
English
70
APPENDICES
Lamp replacing procedure:
1. Switch off the power to the projector by pressing the Power button.
2. Allow the projector to cool down at least 30 minutes.
3. Disconnect the power cord.
4. Remove two screws on the lamp compartment cover.
5. Remove the lamp compartment cover.
6. Disconnect the lamp connector.
7. Remove the two screws from the lamp module. Lift the module handle up.
8. Pull rmly on the module handle to remove the lamp module.
To replace the lamp module, reverse the previous steps. While installing, align the lamp module with the
connector and ensure it is level to avoid damage.
9. Turn on the projector and do “Lamp Reset” after the lamp module is replaced.
Lamp Reset: (i)Press “Menu” -> (ii)Select “Setup” -> (iii)Select “Lamp Settings” -> (iv)Select “Lamp
Reset” -> (v)Select “Yes”.
Warning: Lamp Connector must be installed ush with the connector base as shown in the image below.
A gap between the Lamp Connector and the connector base will cause damage to the projector. The following
images illustrate correct and incorrect Lamp Connector installations.
70


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Optoma EH460ST at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Optoma EH460ST in the language / languages: English as an attachment in your email.

The manual is 16,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Optoma EH460ST

Optoma EH460ST User Manual - German - 79 pages

Optoma EH460ST User Manual - Dutch - 79 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info