63833
57
Zoom out
Zoom in
Previous page
1/124
Next page
57
Basic Operations—Continued
The multichannel DVD input is for connecting a compo-
nent with a 7.1-channel analog audio output, such as a
DVD-Audio or SACD-capable DVD player, or an
MPEG decoder. See page 27 for hookup information.
Notes:
While the multichannel DVD input is selected, the
Speaker Configuration settings on page 75 are
ignored, and signals from the multichannel input are
fed to the speakers as they are.
The multichannel DVD input cannot be used if
“Speakers Type” is set to “Bi-Amp” (see page 47).
This procedure can also be performed on the AV
receiver/AV amplifier by using its [MULTI CH] but-
ton.
You can adjust the bass and treble for the front speakers,
except when the Direct, Pure Audio or THX listening
mode is selected.
Bass
You can boost or cut low-frequency sounds output by the
front speakers from –10 dB to +10 dB in 2 dB steps.
Treble
You can boost or cut high-frequency sounds output by
the front speakers from –10 dB to +10 dB in 2 dB steps.
Notes:
This setting is not available when the multichannel
DVD input is selected.
This procedure can also be performed on the remote
controller by using [AUDIO] button (see page 85).
You can display various information about the current
input source as follows.
Note:
This procedure can also be performed on the AV
receiver/AV amplifier by using its [DISPLAY] button.
The following information can typically be displayed for
input sources.
* If the input signal is analog, no format information is displayed.
If the input signal is PCM, the sampling frequency is displayed.
If the input signal is digital but not PCM, the signal format and
the number of channels is displayed. For some digital input sig-
nals, including multichannel PCM, the signal format, number of
channels, and sampling frequency is displayed.
Information is displayed for about three seconds, then the previ-
ously displayed information reappears.
You can adjust the brightness of the AV receiver/AV
amplifier’s display.
Using the Multichannel DVD Input
Remote
controller
Press the [MULTI CH] button.
“Multich” appears on the display.
Audio from the multichannel DVD
input will now be used for the DVD
input source.
Adjusting the Bass & Treble
1
AV receiver/
AV amplifier
Press the [TONE] button repeat-
edly to select either “Bass” or
“Treble”.
2
Use the Up [r] and Down [e]
buttons to adjust.
Displaying Source Information
Remote
controller
Press the [RECEIVER] button,
and then press the [DISPLAY]
button repeatedly to cycle
through the available informa-
tion.
Setting the Display Brightness
Remote
controller
Press the [RECEIVER] button,
and then press the [DIMMER]
button repeatedly to select:
Normal + VOLUME light on.
Normal + VOLUME light off.
Dim + VOLUME light off.
Dimmer + VOLUME light off.
Alternatively, you can use the AV
receiver/AV amplifier’s [DIMMER]
button (North American models and
TX-SA806 only).
Sampling
frequency
Input source
Signal format*
Listening
mode
TX-SR806_En.book Page 57 Monday, August 4, 2008 10:25 AM
57


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Onkyo TX-SR806 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Onkyo TX-SR806 in the language / languages: English as an attachment in your email.

The manual is 9,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Onkyo TX-SR806

Onkyo TX-SR806 User Manual - German - 242 pages

Onkyo TX-SR806 User Manual - Dutch - 242 pages

Onkyo TX-SR806 User Manual - Italian - 242 pages

Onkyo TX-SR806 User Manual - Swedish - 242 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info