645324
39
Zoom out
Zoom in
Previous page
1/100
Next page
39
First Time Setup—Continued
Notes:
When the room correction and speaker setup is
complete, the Equalizer Settings (page 70) will be set
to “Audyssey” and the “Dynamic EQ” (page 72) will
be set to “On”.
You can cancel the Room Correction and Speaker
Setup at any point in this procedure simply by
disconnecting the setup microphone.
Error Messages
While the room correction and speaker setup is in
progress, one of the following error messages may
appear:
Ambient noise is too high
This message appears if there’s too much background
noise and the measurements cannot be performed
properly. Remove the source of the noise and try again.
Speaker Detect Errors
This message appears if one of the speaker-related errors
below occurs.
One of the front speakers has not been detected.
One of the surround speakers has not been detected.
The surround back speakers have been detected but
the surround speakers haven’t.
The right surround back speaker has been detected but
the left surround back speaker hasn’t.
Write Error
This message appears if saving fails.
Mismatch Error
This message appears if a speaker that was detected
during the 1st measurement is not detected during the
2nd or 3rd measurements. If this message appears, check
your speaker connections, and then try again.
Changing the Speaker Settings Manually
If you wish to make changes to the settings found during
the automatic speaker setup, follow the directions on
pages 66–70.
Using a Powered Subwoofer
If you’re using a powered subwoofer, as it outputs very
low-frequency sound and its position is usually low
down, it may not be detected by the Audyssey 2EQ
Room Correction and Speaker Setup. In this case,
increase the subwoofer’s volume, select its highest
crossover frequency, and then try running the Audyssey
2EQ Room Correction and Speaker Setup again. Note
that if the volume is set too high and the sound distorts,
it may not be detected, so use an appropriate volume
level. If the subwoofer has a low-pass filter switch, set it
to Off or Direct. Refer to your subwoofer’s instruction
manual for details.
5
When the following display appears,
move the speaker setup microphone to
measurement point c (page 37), and
then press [ENTER].
Audyssey 2EQ
performs more
measurements.
This takes a few minutes.
When the measurements are complete, the
results are calculated and saved automatically.
6
When the room correction and speaker
setup is complete, disconnect the
speaker setup microphone.
To Retry the Room Correction and
Speaker Setup
Press the [ENTER] button.
Make sure speakers that cannot be
detected are connected properly.
39


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Onkyo TX-SR507 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Onkyo TX-SR507 in the language / languages: English as an attachment in your email.

The manual is 9,83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Onkyo TX-SR507

Onkyo TX-SR507 User Manual - German - 196 pages

Onkyo TX-SR507 User Manual - Dutch - 196 pages

Onkyo TX-SR507 User Manual - French - 200 pages

Onkyo TX-SR507 User Manual - Italian - 196 pages

Onkyo TX-SR507 User Manual - Swedish - 196 pages

Onkyo TX-SR507 User Manual - Spanish - 200 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info