632469
20
Zoom out
Zoom in
Previous page
1/52
Next page
20
En
You can temporarily mute the output of the AV receiver.
Tip
To unmute, press MUTING again or adjust the volume.
The Mute function is cancelled when the AV receiver is set to
Standby.
With the sleep timer, you can set the AV receiver to turn
off automatically after a specified period.
Tip
If you need to cancel the sleep timer, press SLEEP repeatedly
until the SLEEP indicator goes off.
To check the time remaining until the AV receiver sleeps, press
SLEEP. Note that if you press SLEEP while the sleep time is
being displayed, you’ll shorten the sleep time by 10 minutes.
Note
Always turn down the volume before connecting your head-
phones.
While the headphones plug is inserted in the PHONES jack, the
speakers are turned off.
When you connect a pair of headphones, the listening mode is
set to Stereo, unless it’s already set to Stereo, Mono, or Direct.
The listening modes cannot be selected while a pair of head-
phones is connected.
When you connect an u-capable Onkyo component, you
must configure the input display so that u can work
properly.
This setting can be done only from the front panel.
Note
DOCK can be selected for the TV/CD, GAME or VCR/DVR
input selector, but not at the same time.
Enter the appropriate remote control code before using the
remote controller for the first time ( 41).
You can use two sets of front speakers with the AV
receiver: Speakers A for up to 5.1-channel playback in
your main listening room and Speakers B for 2-channel
stereo playback in another room.
Note
While Speakers B is on, channels are reduced to 2.1 in the main
room ( 10).
Tip
Alternatively, you can use the AV receiver’s SPEAKERS A and
B.
Muting the AV Receiver
Press RECEIVER followed by MUTING.
The output is muted and the MUTING indicator
flashes on the display.
Using the Sleep Timer
Press RECEIVER followed by SLEEP repeatedly
to select the required sleep time.
The sleep time can be set from 90 to 10 minutes in
10 minute steps.
The SLEEP indicator lights on the display when the
sleep timer has been set. The specified sleep time
appears on the display for about five seconds, then
the previous display reappears.
Using Headphones
Connect a pair of stereo headphones with a stan-
dard plug (1/4 inch or 6.3 mm) to the PHONES
jack.
Changing the Input Display
1
Press TV/CD, GAME or VCR/DVR on the front
panel so that “TV/CD”, “GAME” or “VCR/DVR”
appears on the display.
2
Press and hold down TV/CD, GAME or VCR/DVR
(about 3 seconds) to change the input display.
Repeat this step to select “MD”,CDR”, “DOCK
or “TAP E”.
For the TV/CD input selector, the input display
changes in this order:
For the GAME input selector, the setting changes in
this order:
For the VCR/DVR input selector, the setting
changes in this order:
Selecting Speakers A and B
Press RECEIVER followed by SP A/B repeatedly
to cycle through the selection:
A or B, or both indicators light on the display.
TV/CD MD CDR
DOCK
TAPE
GAME DOCK
VCR/DVR DOCK
Speakers A
Speakers A&B Speakers B
Off
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Onkyo TX-SR308 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Onkyo TX-SR308 in the language / languages: English as an attachment in your email.

The manual is 1,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Onkyo TX-SR308

Onkyo TX-SR308 User Manual - German - 104 pages

Onkyo TX-SR308 User Manual - Dutch - 104 pages

Onkyo TX-SR308 User Manual - French - 104 pages

Onkyo TX-SR308 User Manual - Italian - 104 pages

Onkyo TX-SR308 User Manual - Spanish - 104 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info