553769
18
Zoom out
Zoom in
Previous page
1/97
Next page
18
Connecting Speakers
After determining the layout of your speaker system, it
is now necessary to connect the speakers correctly to
your TX-NR801/TX-NR801E.
For the USA and Canadian models, you can also use
banana plugs/connectors.
Caution:
Connect only speakers with an impedance between 4 and
16 to the TX-NR801/TX-NR801E. If the impedance of
even one speaker is between 4 and 6 , be sure to set the
speaker impedance setting accordingly (See page 30).
Notes:
Even if you are using only one speaker or listening to
monaural (mono) sound, never connect a single speaker
in parallel to both the right and left-channel terminals.
To prevent damage to circuitry,
never short-circuit the positive (+)
and negative (–) speaker wire.
Be sure to connect the positive and
negative cables for the speakers
properly. If they are mixed up, the
left and right signals will be reversed
and the audio will sound unnatural.
Do not connect more than one speaker cable to one
speaker terminal. Doing so may damage the
TX-NR801/TX-NR801E.
Connect either your surround back speakers or the
speakers you will be using in the remote zone (Zone
2) to the SURR BACK/ZONE 2 SPEAKERS
terminals (See page 66).
The positive speaker terminals on the TX-NR801/
TX-NR801E are color coded for easy identification.
Attach the supplied speaker labels to the speaker cables,
and then match the colors on the speaker cables to the
corresponding terminals.
The speaker channels are colored as follows:
Front left speaker (+): White
Front right speaker (+): Red
Center speaker (+): Green
Surround left speaker (+): Blue
Surround right speaker (+): Grey
Surround back/Zone 2 left speaker (+): Brown
Surround back/Zone 2 right speaker (+): Tan
R
L
R
L
R
L
R
L
+
+
+
+
Using the Speaker Cable Labels
Speaker cable label
TX-NR801/TX-NR801E
Speaker cable label
SURR
BACK/
ZONE 2
SPEAKERS
AUDIO
VIDEO
S VIDEO
MONITOR
OUT
R
L
IN
IN
IN
IN
IN
ZONE 2
DVD
VIDEO 1
VIDEO 2
VIDEO 3
VIDEO 4
AUDIO
VIDEO
S VIDEO
COMPONENT
VIDEO
Y
P
B
P
R
OUTPUT
INPUT 1
Y
P
B
P
R
INPUT 2
Y
P
B
P
R
FRONT SPEAKERS
L
RL
R
SURR SPEAKERS
CENTER
SPEAKER
R
L
R
L
OUT
OUT
OUT
I
R
IN
OUT
REMOTE
CONTROL
PHONO
DIGITAL
IN
PRE OUT
DIGITAL
OUT
OPT
OPT
2
1
2
1
2
3
FRONT
SUB
SURR
R
L
AUDIO
R
L
CD
TAPE
R
L
AUDIO
1
3
GND
SURR
BACK/
ZONE 2
IN
OUT
COAX
R
L
MULTI
CH
INPUT
FRONT
SUB
SURR
SURR
BACK
CENTER
R
L
R
L
AM
FM
75
CENTER
ANTENNA
IN
IN
(
Net
-
Tune
)
ETHERNET
4 OHMS MIN. OR
6 OHMS MIN.
/SPEAKER
CAUTION
:
SPEAKER
IMPEDANCE
SEE INSTRUCTION
MANUAL FOR
CORRECT SETTINGS.
AC OUTLETS
AC
120
V 60
Hz
SWITCHED
TOTAL 120W 1A MAX.
AV RECEIVER
MODEL NO.
TX
-
NR
801
VOLTAGE
SELECTOR
220
-
230V
120V
25341
5/8"
(15mm)
Use the PRE OUT
SUBWOOFER jack to connect
a subwoofer with a built-in
power amplifier. If your
subwoofer does not have a
built-in amplifier, connect an
amplifier to the PRE OUT
SUBWOOFER jack and the
subwoofer to the amplifier.
Subwoofer
Front
right
speaker
Front
left
speaker
Surround
right
speaker
Surround
left
speaker
Center
speaker
Surround
back
right
speaker
Surround
back left
speaker
Connecting the speaker cable
1. Strip away approx. 5/8 inch (15 mm) of
the wire insulation.
2. Twist the wire ends tightly together.
3. Unscrew the speaker terminal cap.
4. Insert the exposed wire end.
5. Screw down the speaker terminal cap.
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Onkyo TX-NR801 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Onkyo TX-NR801 in the language / languages: English as an attachment in your email.

The manual is 5,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info