462089
46
Zoom out
Zoom in
Previous page
1/88
Next page
46
En
Speaker Impedance
(European, Australian and Asian models)
` 4ohms:
Select if the impedance of any speaker is 4 ohms or
more but less than 6.
` 6ohms
:
Select if the impedances of all speakers are between
6 and 16 ohms.
Note
(North American and Taiwan models) Speakers with an
impedance of less than 6 ohms are not supported.
Speakers Type (Front)
` Normal
:
Select this if you’ve connected your front speakers
normally.
` Bi-Amp:
Select this if you’ve bi-amped your front speakers.
Powered Zone 2
` No
` Yes:
Zone 2 speakers can be used. (Powered Zone 2
enabled).
Note
•If theSpeakers Type (Front)” setting is set to “Bi-Amp”,
Powered Zone 2 cannot be used.
When the “Powered Zone 2” setting is set to “Yes”, the
surround back or front high speakers cannot be used.
Speaker Configuration
With these settings, you can specify which speakers are
connected and a crossover frequency for each speaker.
Specify “Full Band” for speakers that can output low
frequency bass sounds adequately, for example, speakers
with a good sized woofer. For smaller speakers, specify a
crossover frequency. Sounds below the crossover
frequency will be output by the subwoofer instead of the
speaker. Refer to your speaker’s manuals to determine the
optimum crossover frequencies. If you set up your
speakers using Audyssey 2EQ
®
Room Correction and
Speaker Setup, please make sure manually that any THX
speakers are set to “80Hz(THX)” crossover.
Note
These settings are not available in either of the following cases:
a pair of headphones is connected.
–theAudio TV Out” setting is set to “On” ( page 57).
–“HDMI Control (RIHD)” is set to “On” ( page 56) and
you’re listening through your TV speakers.
Subwoofer
` Yes
` No
Front
` Full Band
` 40Hz to 80Hz(THX)
to 100Hz, 120Hz, 150Hz,
200Hz
Note
•If theSubwoofer” setting is set to “No”, the “Front” setting is
fixed at “Full Band”.
Center
*1
, Surround
*1
, Surround Back
*2*3*4*5
` Full Band
` 40Hz to 80Hz(THX)
to 100Hz, 120Hz, 150Hz,
200Hz
` None
Front High
*1*2*4*6
` Full Band
` 40Hz to 80Hz(THX) to 100Hz, 120Hz, 150Hz,
200Hz
` None
Note
*1
Full Band” can be selected only when “Full Band” is
selected in the “Front” setting.
*2
If the “Surround” setting is set to “None”, this setting cannot
be selected.
*3
If the “Surround” setting is set to anything other than “Full
Band”, “Full Band” cannot be selected here.
*4
If the “Speakers Type (Front)” setting is set to “Bi-Amp”, or
the “Powered Zone 2” setting is set to “Yes”, this setting
cannot be selected.
*5
If anything else than “None” is selected in Front High”, this
setting is automatically set to “None”.
*6
If anything else than “None” is selected in “Surround Back”,
this setting is automatically set to “None”.
Surround Back Ch
` 1ch:
Select if only one surround back speaker L is
connected.
` 2ch
:
Select if two (left and right) surround back speakers
are connected.
Note
•If theSurround Back” Setting is set to “None”, this setting
cannot be selected.
LPF of LFE
(Low-Pass Filter for the LFE Channel)
` 80Hz, 90Hz, 100Hz, 120Hz
` Bypass:
Low-Pass Filter is not applied.
With this setting, you can specify the cutoff frequency
of the LFE channel’s low-pass filter (LPF), which can
be used to filter out unwanted hum. The LPF only
applies to sources that use the LFE channel.
Note
If you’re using THX-certified speakers, select “80Hz”.
46


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Onkyo TX-NR609 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Onkyo TX-NR609 in the language / languages: English as an attachment in your email.

The manual is 2,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Onkyo TX-NR609

Onkyo TX-NR609 User Manual - German - 176 pages

Onkyo TX-NR609 User Manual - Dutch - 176 pages

Onkyo TX-NR609 User Manual - French - 176 pages

Onkyo TX-NR609 User Manual - Italian - 176 pages

Onkyo TX-NR609 User Manual - Swedish - 176 pages

Onkyo TX-NR609 User Manual - Spanish - 176 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info