527525
48
Zoom out
Zoom in
Previous page
1/120
Next page
Advanced Operations
En-48
Operating
procedure
( page 44)
Here you can adjust the level of each speaker with
the built-in test tone so that the volume of each
speaker is the same at the listening position.
Note
These settings cannot be calibrated in either of the
following cases:
A pair of headphones is connected.
The “Audio TV Out” setting is set to “On” ( page 53).
–“HDMI CEC (RIHD)” is set to “On” ( page 52) and
you’re listening through your TV speakers.
The AV receiver is muted.
Left, Center
*1
, Right, Surround Right, Surround
Left
` –12 dB to 0dB
to +12 dB in 1 dB steps.
Subwoofer
*1
` –15 dB to 0dB to +12 dB in 1 dB steps.
Note
Speakers that you set to “No” or “None” in “4. Sp Config
(Speaker Configuration)” ( page 46) cannot be selected.
*1
For the center speaker and subwoofer, the level settings
made by using the Quick Setup are saved in this menu
( page 42).
Tip
If you’re using a handheld sound level meter, adjust the
level of each speaker so that it reads 75 dB SPL at the
listening position, measured with C-weighting and slow
reading.
With the Audio Adjust functions and settings, you can
adjust the sound and listening modes as you like.
Multiplex/Mono
Multiplex
Input Ch (Mux)
` Main
` Sub
` Main/Sub
This setting determines which channel of a stereo
multiplex source is output. Use it to select audio
channels or languages with multiplex sources,
multilingual TV broadcasts, and so on.
Mono
Input Ch (Mono)
` Left+Right
` Left
` Right
This setting specifies the channel to be used for
playing any 2-channel digital source such as Dolby
Digital, or 2-channel analog/PCM source in the Mono
listening mode.
Dolby
PL II Music (2ch Input)
These settings apply to only 2-channel stereo
sources.
Panorama
` On
` Off
With this setting, you can broaden the width of the
front stereo image when using the Dolby Pro Logic II
Music listening mode.
Dimension
` –3 to 0
to +3
With this setting, you can move the sound field
forward or backward when using the Dolby Pro Logic
II Music listening mode. Higher settings move the
sound field backward. Lower settings move it forward.
If the stereo image feels too wide, or there’s too much
surround sound, move the sound field forward to
improve the balance. Conversely, if the stereo image
feels like it’s in mono, or there’s not enough surround
sound, move it backward.
Center Width
` 0 to 3
to 7
With this setting, you can adjust the width of the
sound from the center speaker when using the Dolby
Pro Logic II Music listening mode. Normally, if you’re
using a center speaker, the center channel sound is
output from only the center speaker. (If you’re not
using a center speaker, the center channel sound will
be distributed to the front left and right speakers to
create a phantom center.) This setting controls the
front left, right, and center mix, allowing you to adjust
the weight of the center channel sound.
6. Level Cal (Level Calibration)
This setting is set automatically by
Audyssey MultEQ
®
Room Correction and Speaker
Setup function ( page 21).
7. Audio Adjust
48


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Onkyo TX-NR525 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Onkyo TX-NR525 in the language / languages: English as an attachment in your email.

The manual is 2,56 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Onkyo TX-NR525

Onkyo TX-NR525 Quick start guide - English - 4 pages

Onkyo TX-NR525 Quick start guide - German - 4 pages

Onkyo TX-NR525 User Manual - German - 124 pages

Onkyo TX-NR525 Quick start guide - Dutch - 4 pages

Onkyo TX-NR525 User Manual - Dutch - 124 pages

Onkyo TX-NR525 Quick start guide - French - 4 pages

Onkyo TX-NR525 User Manual - French - 124 pages

Onkyo TX-NR525 Quick start guide - Italian - 4 pages

Onkyo TX-NR525 User Manual - Italian - 124 pages

Onkyo TX-NR525 User Manual - Swedish - 120 pages

Onkyo TX-NR525 User Manual - Spanish - 124 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info