492661
58
Zoom out
Zoom in
Previous page
1/168
Next page
Advanced Operations
En-58
Listening Mode
*7
` You can select the listening modes that are grouped in
the following categories: MOVIE/TV”, “MUSIC”,
GAME”, and “THX”.
Use q/w to select the category and e/r to select the
listening mode. Press ENTER to switch to the
selected listening mode.
Note
*1
The video preview is not displayed when:
HDMI IN 5/6/7/8 is the current HDMI input source, or
No signal is present on the current input source, or
–TheZone 2 HDMI” setting is set to “Use” ( page 63).
The video of the currently-selected input is displayed on the
main screen, not on a preview thumbnail.
*2
Dolby Volume”, “Dynamic EQ” and “Dynamic Volume
cannot be selected when any of the THX listening modes is
selected, with “Loudness Plus” set to “On” or “Preserve
THX Settings” set to “Yes” ( page 70).
*3
When “Dynamic EQ” is set to “On” or “Dynamic Volume
is set to anything else than “Off”, “Dolby Volume” will be
switched to “Off” ( page 73).
*4
When the “Monitor Out” setting is set to “Sub”, “Video
cannot be selected ( page 63).
This setting cannot be used with the NET input selector.
*5
Only when you have selected “Custom” in the “Picture
Mode” ( page 78), pressing ENTER allows you to adjust
the following items via the Quick Setup: “Brightness”,
Contrast”, “Hue” and “Saturation”. Press RETURN to
return to the “Picture Mode” setting.
*6
Depending on the input source and listening mode, not all
channels shown here output the sound.
*7
This setting is not available in either of the following cases:
–TheAudio TV Out” setting is set to “On” ( page 84).
–“HDMI Control(RIHD)” is set to “On” ( page 83) and
you’re listening through your TV speakers.
You can change various audio settings from the Quick
Setup ( page 57).
Note
These settings are not available in either of the following cases:
–TheAudio TV Out” setting is set to “On” ( page 84).
–“HDMI Control(RIHD)” is set to “On” ( page 83) and
you’re listening through your TV speakers.
Sound Program
Sound Program
` Stereo Source 1, Stereo Source 2, Stereo Source 3,
Multich Source 1, Multich Source 2, Multich
Source 3
` Off
With this setting, you can select the combination of
settings that you registered in “Sound Program Edit
( page 75).
Note
If the input selector is changed, the “Sound Program” setting is
switched back to “Off”.
Tone Control
Bass
` –10dB to 0dB
to +10dB in 2 dB steps.
You can boost or cut low-frequency sounds output.
Treble
` –10dB to 0dB to +10dB in 2 dB steps.
You can boost or cut high-frequency sounds output.
You can adjust the bass for the front, front wide, front high,
center, surround, surround back and subwoofer speakers
and treble for the front, front wide, front high, center,
surround and surround back speakers, except when the
Direct, Pure Audio or THX listening mode is selected.
Operating on the AV receiver
Note
Speakers that are set to “No” or “None” in “Speaker
Configuration” ( page 67) cannot be adjusted.
When “Sound Program” is enabled, “Subwoofer 1” and
Subwoofer 2” cannot be used if the “Subwoofer” setting is set
to “No” in “Sound Program Edit” ( page 75).
Using the Audio Settings of Quick
Setup
1
Press TONE repeatedly to select either “Bass” or
“Treble” for each speaker or subwoofer.
2
Use and + to adjust.
58


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Onkyo TX-NR3010 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Onkyo TX-NR3010 in the language / languages: English as an attachment in your email.

The manual is 4,85 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Onkyo TX-NR3010

Onkyo TX-NR3010 User Manual - German - 168 pages

Onkyo TX-NR3010 User Manual - Dutch - 168 pages

Onkyo TX-NR3010 User Manual - French - 168 pages

Onkyo TX-NR3010 User Manual - Italian - 168 pages

Onkyo TX-NR3010 User Manual - Swedish - 168 pages

Onkyo TX-NR3010 User Manual - Spanish - 168 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info