553759
9
Zoom out
Zoom in
Previous page
1/76
Next page
9
Front panel facilities
Front panel
POWER
After plugging in the power cord into the rear panel and wall
outlet, pressing this button connects the TX-DS989 to the AC
mains and turns it on.
Before turning on the power, make sure all cables are properly
connected.
Turning on the TX-DS989 may cause a momentary power
surge that might interfere with other electrical equipment on
the same circuit. If this is a problem, plug the TX-DS989 into a
different electrical circuit.
STANDBY/ON
Pressing this button while the main power is turned on the
STANDBY indicator lights up and the front display turns off.
Pressing it again returns it to the standby state. This state turns off
the display, disables control functions, and turns off all outputs to
the main zone (those for the remote zone remain available).
STANDBY indicator
MASTER VOLUME
The MASTER VOLUME knob is used to control the volume for
the main zone. The volume for the remote zone (Zone 2) is
independent.
OPEN/CLOSE
Press this button to open and close the front door that covers the
lower buttons.
DISPLAY
The DISPLAY button is used to display information about the
current input source signal. Each time you press the display
button, the screen changes to show you different information
concerning the input signal. The screen changes as follows:
Program format Sampling frequency Digital input Digital
format Bass level Treble level.
If the input source signal does not have any information for a
particular screen, then that screen will be skipped.
Displaying the data of the current input source
Each display is explained below.
Input Source Buttons (DVD, VIDEO 15,
TAPE 12, AM, FM, PHONO, and CD)
These buttons are used to select the input source for the main zone.
When an input source is selected, the indicator will light in orange.
To select the input source for the remote zone (Zone 2) or
recording out (Rec Out), first press the Zone 2 or Rec Out button,
and then the desired input source button.
Lower buttons in the front door
Caution:
The front door of the receiver is motorized. Use the open/close
button to open or close the door. Manually opening or closing
the door, or moving the receiver while holding the door, will
cause the door to malfunction or break.
Rec Out
Press the Rec Out button to output to a recording component for
recording purposes. After pressing the Rec Out button, press one
of the input source selector buttons within 8 seconds to select the
component to record to. When one is selected, the indicator above
that button will light in red. To record from the same input source
that you are using (that is selected for the main zone), press the
Rec Out button twice in succession.
Note:
The Rec Out and Zone 2 buttons use the same circuit and therefore
cannot be used at the same time.
When Rec Out is selected, nothing is output from Zone 2.
Zone 2
The TX-DS989 includes a second signal path separate from the
main one that can be used for a remote zone (Zone 2) or for making
recordings. By connecting an additional amplifier or other video
equipment to the Zone 2 outputs, you can output to a separate
room an input source that is different from that being used in the
main room. This allows you to watch one program in one room
while somebody else is watching a different program in another.
Press the Zone 2 button to enable output to the ZONE 2 outputs.
After pressing the Zone 2 button, press one of the input source
selector buttons within 8 seconds to select the input source for the
remote zone. When one is selected, the indicator above that button
will light in green. To use the same input source for the both the
main and remote zones, press the Zone 2 button twice in
succession.
Note:
The Rec Out and Zone 2 buttons use the same circuit and therefore
cannot be used at the same time.
When Zone 2 is selected, the currently selected input source is
output from the recording terminal.
Program
format:
Front channel Surround channel
Sampling
frequency:
Source signal 48 kHz
Sampling frequency
Digital input:
The current input source is set for
digital input at OPT1.
Digital format:
The current input source is set for
a digital format of Auto.
Bass level:
The current bass level is +2.
Treble level:
The current treble level is -2.
LFE(Low Frequency Effect)
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Onkyo TX-DS989 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Onkyo TX-DS989 in the language / languages: English as an attachment in your email.

The manual is 2,63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info