553756
9
Zoom out
Zoom in
Previous page
1/76
Next page
9
Front panel facilities
PHONES jack
This is a standard stereo jack for connecting stereo headphones.
The audio for the front right and left speakers are sent to the
headphone speakers. When the headphones are plugged in, the
listening mode automatically changes to stereo and output to the
speakers is stopped.
AUDIO SELECTOR button
This button is used to select the type of audio input signal. Each
time pressed, the setting cycles from AUTO Multichannel
Analog and back.
AUTO (automatic detection): With this setting, the TX-DS787
automatically detects whether the input signal is digital or
analog. When a digital signal is not input, then the analog
signal is played.
Multichannel: Select this setting to play back the input from the
component connected to the MULTI CHANNEL INPUT port.
This setting is effective when the Multichannel setting in the
Audio Setup sub-menu is set to Yes (see page 35).
Analog: Select this setting to play back the input from a source
component connected to an AUDIO IN jack. With this setting,
even if a digital signal is input from the same component, only
the analog signal will be output.
Input Source Buttons (DVD, VIDEO 14,
TAPE, FM, AM, PHONO, and CD)
These buttons are used to select the input source for the main zone.
To select the input source for the remote zone (Zone 2) or
recording out (Rec Out), first press the Zone 2 or Rec Out button,
and then the desired input source button.
VIDEO 4/VIDEO CAM INPUT
These inputs are for connecting video cameras and other such
equipment.
RT/PTY/TP (European models only) button
This button is only available on European models. Use this button
to help tune into the Radio Data System (RDS) for FM
broadcasting. RDS was developed within the European
Broadcasting Union (EBU) and is available in most European
countries. Each time the button is pressed, the display changes
from RT (radio text) to PTY (program type) to TP (traffic
program) and then back to RT again.
DIMMER (other than European models)
button
Press to set the brightness of the front display. There are 3 settings
available: normal, dark, and very dark.
The dimmer control for the front display can also be performed
at the remote controller.
Front display
Front panel
POWER switch
Turns on and off the main power supply for the TX-DS787.
Before turning on the power, make sure all cables are properly
connected.
Turning on the TX-DS787 may cause a momentary power
surge that might interfere with other electrical equipment on
the same circuit. If this is a problem, plug the TX-DS787 into a
different electrical circuit.
STANDBY indicator
Lights when the TX-DS787 is in the standby state and flashes
when a signal is received from the remote controller.
STANDBY/ON button
Pressing this button while the main power is turned on the
STANDBY indicator lights up and the front display turns off.
Pressing it again returns it to the standby state. This state turns off
the display, disables control functions.
ZONE 2 indicator
Lights when a signal is output to the remote zone (Zone 2). When
the ZONE 2 indicator is off, then either output to the remote zone
is turned off or Rec Out is selected.
REC OUT/ZONE 2 buttons
These buttons allow you to use the TX-DS787 to output to a
remote zone (Zone 2) or to another component for recording
purposes (Rec Out). Press the REC OUT button to output the audio
and video signals to a recording component for recording
purposes. Press the ZONE 2 button to enjoy the output from the
TX-DS787 in a different room, which is referred to as a remote
zone (Zone 2).
When either button is pressed, the currently selected input source
for recording or outputting to the remote zone is displayed in the
front panel display. If SOURCE is displayed, then the same
input source as that selected for the main zone will be output.
To select an input source, press the desired button (REC OUT or
ZONE 2) and then press one of the input source button within 3
seconds. That source will be output for recording or viewing in the
remote zone. To turn off either the REC OUT or ZONE 2 output,
when SOURCE is displayed, press the button again. OFF
appears in the front display.
Notes:
The Rec Out and Zone 2 buttons use the same circuit and
therefore cannot be used at the same time. When Rec Out is
selected, nothing is output to Zone 2, and vice versa.
When not using Rec Out or Zone 2, turn off the signal. If
turned on and the connected component is not turned on, the
electric signal will still be sent through the circuitry and the
excess load may cause deterioration of the audio signal.
MASTER VOLUME dial
The MASTER VOLUME dial is used to control the volume for the
main zone. The volume for the remote zone (Zone 2) is
independent.
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Onkyo TX-DS787 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Onkyo TX-DS787 in the language / languages: English as an attachment in your email.

The manual is 2,06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Onkyo TX-DS787

Onkyo TX-DS787 User Manual - French - 74 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info