549890
6
Zoom out
Zoom in
Previous page
1/12
Next page
En-6
Adjustments
Crossover frequency and output level
Adjust the SKW-208 output level and crossover fre-
quency to suit your listening room and connected
speakers.
Be aware that you might set the subwoofer to a high
output level because superbass-range sound is less
audible than other sound ranges. To obtain well-bal-
anced frequency characteristics, set the output level
to a slightly lower level than seems optimal. (This
will also prevent the input of signals that are too
strong.)
Note:
Be careful not to allow the input of excessive power.
Input levels that greatly exceed normal situations can
damage the SKW-208. Also note that switching opera-
tions at the amplifier may generate excessive noise that
may result in damage. When using switches at the ampli-
fier, first lower the volume to prevent accidental damage.
Placement
The placement of the SKW-208 can greatly affect the
sound that is produced. In general, a good bass sound
can be obtained by installing the subwoofer in a front
corner, or at one-third the width of the wall, as shown.
Troubleshooting
The unit does not turn on
The power plug is not fully inserted.
Insert the power plug fully into the power outlet.
No sound is output
The OUTPUT LEVEL knob is set to the MIN level.
Set the OUTPUT LEVEL knob properly.
Pin connector cable is not properly connected to the
LINE INPUT jack.
The speaker setting at the amplifier (or receiver) is
incorrect.
Check the settings at the amplifier (or receiver).
The input signal is so small that the unit entered
Standby mode.
Slightly increase the output level at the amplifier
(or receiver).
If the STANDBY/ON indicator lights up (both red and
blue LEDs) several seconds or minutes after the sound
output stopped, this means that the amp protection cir-
cuit has been activated. In this case, set the OUTPUT
LEVEL knob to the center position, and disconnect
the power cord from the AC outlet. Wait at least 10
seconds, and then reconnect the power cord. If that
doesn’t solve the issue, contact your Onkyo dealer.
Low sound output
The sound source might not include a superbass range.
Play a sound source that includes a superbass
range.
Hum noise
Pin connector plug is not inserted completely.
Fully insert the pin connector plug.
External leakage flux (induction noise by TV, etc.)
occurs.
Relocate the SKW-208 away from the noise
source and re-connect.
Specifications
Type Bass-reflex with built-in
power amplifier
Input sensitivity/impedance
550 mV / 20 k
Frequency response 25–200 Hz
Rated output power 120 watts minimum contin-
uos power, 4 ohms, driven at
100 Hz with a maximum total
harmonic distortion of 1 %
Cabinet capacity 37 L (1.3 cubic feet)
Drivers unit 25 cm (10 inch) cone woofer
Power supply AC 230 V, 50 Hz
Power consumption 150 W
Dimensions (W H D) 275 507 411 mm
(10-13/16" 19-15/16"
16-3/16")
Weight 11.6 kg (25.6 lbs.)
Accessory Pin connector cable (1 pc.)
Instruction manual (this man-
ual)
Floor pad (4 pcs.)
Others Auto standby
Specifications and appearance are subject to change
without prior notice.
Corner
1/3 room
length
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Onkyo SKW-208 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Onkyo SKW-208 in the language / languages: English, German as an attachment in your email.

The manual is 1,69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info