462101
45
Zoom out
Zoom in
Previous page
1/172
Next page
45
En
Level Calibration
Here you can adjust the level of each speaker with the
built-in test tone so that the volume of each speaker is the
same at the listening position.
Left, Front High Left, Center
*1
, Front High Right,
Right, Surround Right, Surround Back Right,
Surround Back Left, Surround Left
` –12dB to 0dB to +12dB in 1 dB steps.
Subwoofer
*1
` –15dB to 0dB to +12dB in 1 dB steps.
Note
These settings cannot be calibrated in either of the following
cases:
a pair of headphones is connected.
–theAudio TV Out” setting is set to “On” ( page 55).
–“HDMI Control(RIHD)” is set to “On” ( page 54) and
you’re listening through your TV speakers.
the AV receiver is muted.
Speakers that you set to “No” in the “Speaker Configuration”
cannot be selected ( page 44).
The test tone is output at the standard level for THX, which is
0 dB (absolute volume setting 82). If you normally listen at
volume settings below this, be careful because the test tone will
be much louder.
*1
For the center speaker and subwoofer, the level settings made
by using the Home menu are saved in this menu
( page 39).
Tip
If you’re using a handheld sound level meter, adjust the level of
each speaker so that it reads 75 dB SPL at the listening position,
measured with C-weighting and slow reading.
Equalizer Settings
With the Equalizer settings, you can adjust the tone of
speakers individually with a 5-band equalizer. The volume
of each speaker can be set.
Equalizer
` Manual:
You can adjust the equalizer for each speaker
manually. Continue with the following procedure:
` Off
:
Tone off, response flat.
Note
You can select: “63Hz”, “250Hz”, “1000Hz”, “4000Hz”, or
16000Hz”. And for the subwoofer, “25Hz”, “40Hz”, “63Hz”,
100Hz”, or “160Hz”.
When the Direct listening mode is selected, the equalizer
settings have no effect.
If “Audyssey” is enabled, it prevails over this setting
( page 48).
This setting is set automatically by Audyssey 2EQ
Room Correction and Speaker Setup ( page 30).
Adjust the level control of the subwoofer to the THX
POSITION before calibrating this system.
1
Press w to select “Channel”, and then use
e/r to select a speaker.
2
Use q/w to select a frequency, and then use
the e/r to adjust the level at that frequency.
The volume at each frequency can be adjusted
from –6dB to 0dB
to +6dB in 1 dB steps.
Tip
Low frequencies (e.g., 63Hz) affect bass sounds;
high frequencies (e.g., 16000Hz) affect treble
sounds.
3
Use q to select “Channel”, and then use e/r
to select another speaker.
Repeat steps 1 and 2 for each speaker.
You cannot select speakers that you set to “No
in the “Speaker Configuration” ( page 44).
45


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Onkyo HT-R990 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Onkyo HT-R990 in the language / languages: English, French as an attachment in your email.

The manual is 4,16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Onkyo HT-R990

Onkyo HT-R990 User Manual - German, Dutch, Swedish - 256 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info