136788
57
Zoom out
Zoom in
Previous page
1/60
Next page
57
Troubleshooting
If you have any trouble using your DV-SP501, check the following table for possible causes and remedies. If you still
can’t resolve the issue yourself, please contact your Onkyo dealer.
Symptoms Causes Remedies
DVD Player
Can’t turn on the
DV-SP501?
The power cord is not connected.
Connect the power cord to a suitable wall outlet
(page 23).
The [POWER] switch is set to OFF. Set the [POWER] switch to ON (page 23).
External interference is affecting the
DV-SP501’s digital circuitry.
Turn off the DV-SP501, wait five seconds, then try
turning it on again. If that fails, disconnect the
power cord from the wall outlet, wait five seconds,
reconnect it, then try turning it on again.
The disc tray won’t close
properly?
The disc is not centered in the disc tray.
Place the disc in the center of the disc tray
(page 26).
The disc is dirty. Remove the disc and clean it (page 10).
Can’t start playback?
No disc is loaded. Load a disc (page 26).
The disc cannot be played because its
incompatible.
Use only compatible discs (page 8).
The disc is upside down. Load the disc the correct way up (page 26).
The disc is not centered in the disc tray.
Place the disc in the center of the disc tray
(page 26).
The disc is dirty. Remove the disc and clean it (page 10).
The disc uses parental lock and the Paren-
tal Lock function is on.
Turn off the Parental Lock function (page 48).
The DVD-Video disc is intended for use in
another region.
If the region number on the disc does not match
the region number on the DV-SP501, the disc
can’t be played (page 51).
The picture distorts occa-
sionally?
The disc is dirty. Remove the disc and clean it (page 10).
Yo u’re using the Fast Forward or Fast
Reverse function.
A little picture distortion may occur when using
these functions. This is normal.
Picture instability or noise?
The DV-SP501 is connected to your TV
via a VCR or other video equipment and a
copy-protection system is affecting the
picture.
Connect the DV-SP501 directly to your TV
(page 19).
No picture?
The wrong input source is selected on
your TV.
On your TV, select the input to which the
DV-SP501 is connected.
The video cable is not connected properly.
Check the video cable and correct as necessary
(page 19).
Settings are not saved?
If there’s a power failure, or the power
cord is disconnected inadvertently, any
settings are lost.
Before you disconnect the power cord, set the
DV-SP501 to Standby by pressing the [STANDBY/
ON] button, and wait until “GOOD BYE” has dis-
appeared from the display.
Brightness is unstable or
the picture is noisy?
The DV-SP501 is connected to your TV
via a VCR or other video equipment and a
copy-protection system is affecting the
picture.
Connect the DV-SP501 directly to your TV
(page 19).
Your TV doesn’t support progressive scan-
ning.
Reset the DV-SP501 to its initial settings
(page 45).
Chapters or tracks don’t
play in the correct order?
You are using repeat playback, program
playback, or random playback.
Select normal playback (pages 32–35).
DV-SP501_En.book Page 57 Tuesday, May 20, 2003 4:17 PM
57


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Onkyo dv sp 501 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Onkyo dv sp 501 in the language / languages: English as an attachment in your email.

The manual is 2,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info