136557
94
Zoom out
Zoom in
Previous page
1/96
Next page
94
Troubleshooting
—Continued
SACD audio is not output
by the i.LINK sockets?
This is because the i.LINK Output Setting is
set to Off. If the DV-SP1000/DV-SP1000E is
properly connected to an i.LINK component
and an SACD is loaded, the IEEE 1394 indica-
tor will flash.
Set the i.LINK Output Setting to On (page 76).
The i.LINK cables are not connected properly.
Check the i.LINK connections and correct as nec-
essary (page 35).
SACD audio is not output
by the analog audio out-
puts?
This is because the i.LINK Output Setting is
set to On.
Set the i.LINK Output Setting to Off (page 76).
Can’t access the Analog
Audio Out settings?
While the i.LINK Output Setting is set to On,
the Analog Audio Out Speaker Setting,
Speaker Distance, and Test Tone settings have
no effect and are unavailable.
Set the i.LINK Output Setting to Off (page 76).
Can’t play MP3 and JPEG
discs?
The disc is not ISO 9660 Level 2 format. Use only ISO 9660 Level 2 format discs (page 10).
The disc has not been finalized. Finalize the disc (page 10).
Can’t select MP3 files?
MP3 files without a “.mp3” or “.MP3” file-
name extension are not recognized.
Use the correct filename extension (page 10).
The MP3 disc is a multisession disc.
Only files in the first session of a multisession disc
can be played (page 10).
Can’t view JPEG files?
JPEG files without a “.jpg” or “.JPG” or
“.JPEG” filename extension are not recog-
nized.
Use the correct filename extension (page 10).
Only Baseline JPEG files are supported. Pro-
gressive JPEG files are not.
Use Baseline JPEG files (page 10).
Only JPEG files with the following brightness/
color difference ratios are supported: 4:4:4,
4:2:2, and 4:1:1.
Use JPEG files with the supported ratio (page 10).
The JPEG file is too big. Use JPEG files that are less than 5 MB (page 10).
The message “NO PLAY”
appears on the display?
The disc is dirty. Remove the disc and clean it (page 11).
Buttons on the remote con-
troller don’t work?
Power supply voltage fluctuations and other
anomalies, such as static electricity, can inter-
fere with normal operation.
Turn off the DV-SP1000/DV-SP1000E, wait five
seconds, then turn it on again. If that doesn’t
resolve the issue, disconnect the power cord from
the wall outlet, wait five seconds, reconnect it, then
try again.
Buttons on the
DV-SP1000/DV-SP1000E
work OK but those on the
remote controller don’t?
There are no batteries in the remote controller. Install new batteries (page 14).
The batteries are flat. Replace with new batteries (page 14).
The batteries are installed incorrectly.
Check the batteries and correct as necessary
(page 14).
You’re not pointing the remote controller at the
DV-SP1000/DV-SP1000E’s remote sensor.
Point the remote controller at the DV-SP1000/
DV-SP1000E’s remote sensor (page 14).
You’re too far away from the DV-SP1000/
DV-SP1000E.
Use the remote controller closer to the
DV-SP1000/DV-SP1000E (page 14). The remote
controller has a range of approximately 16 ft. (5
meters).
A strong light source is interfering with the
DV-SP1000/DV-SP1000E’s remote sensor.
Make sure that the DV-SP1000/DV-SP1000E is
not subjected to direct sunshine or inverter-type flu-
orescent lights. Relocate if necessary.
If the DV-SP1000/DV-SP1000E is installed in
a cabinet with colored glass doors, the remote
controller may not work reliably when the
doors are closed.
Open the doors, or use a cabinet without colored
glass.
94


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Onkyo dv sp 1000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Onkyo dv sp 1000 in the language / languages: English as an attachment in your email.

The manual is 4,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Onkyo dv sp 1000

Onkyo dv sp 1000 User Manual - French, Spanish - 192 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info