371103
27
Zoom out
Zoom in
Previous page
1/88
Next page
2727
Setting the TV System
The default setting of the DVD Receiver is AUTO, and unless you
notice that the picture is distorted when playing some discs, you
should leave it set to AUTO.
If you experience picture distortion with some discs, set the TV
system to match your country or regions system. Doing this,
however, may restrict the kinds of disc you can watch. The table
below shows what kinds of disc are compatible with each setting
(AUTO, PAL and NTSC).
1 Switch the DVD Receiver into standby.
2 Hold down ¢ then press STANDBY/ON until the display
indicates the new setting to switch the TV system.
The TV system changes as follows:
AUTO = NTSC
NTSC = PAL
PAL = AUTO
Note that you have to switch the DVD receiver into standby
before each change.
About MOD. (Modulation) PAL
SHRINK
Most models of the newly developed countdown PAL TV system
detect 50 Hz (PAL)/60 Hz (NTSC) and automatically switch
vertical amplitude, resulting in a display without vertical
shrinkage.
If your PAL TV does not have a V-Hold control, you may not be
able to view NTSC disc because the picture may roll. If the TV
has a V-Hold control, adjust it until the picture stops rolling. On
some TVs, the picture may shrink vertically, leaving black bands
at the top and bottom of the screen. This is not a malfunction; it is
caused by the NTSC = PAL conversion.
Type
DVD
Video CD
CD, No disc
Format
NTSC
PAL
NTSC
PAL
Disc Output format
Position of TV SYSTEM mode
NTSC PAL AUTO
NTSC MOD. PAL NTSC
PAL PAL
NTSC MOD. PAL NTSC
NTSC PAL PAL
NTSC PAL NTSC or PAL
Turning the unit on/off with the TVs power
switch IPM function
The DVD Receiver is equipped with the (IPM) system.
Just turn on your TVs power switch and, in about 5 seconds,
the DVD Receiver turns on automatically. If you turn off the
TVs power switch, IPM indicator flashes on the display and
the DVD Receiver automatically turns off in about 5 minutes.
To activate the IPM function
1 Connect the audio output of your TVs audio output to the
DVD Receivers TV/LINE IN L/R jacks (refer to pages 18
and 19).
Even when connected with SCART cable, audio
connection to TV/LINE IN L/R jacks is needed (European
model).
2 Press IPM on the remote controller repeatedly to turn on
the IPM indicator on the unit.
Notes
The IPM system may not function properly with some TV sets.
When using monaural TV, connect the audio output of the TV to
the DVD Receivers TV/LINE IN L jack.
When the TV is turned off while the DVD Receiver selects other
input source, the DVD Receiver does not turn off.
IPM
LATE NIGHT
7
Before operating the
remote controller
Press MODE TV/SETUP.
Theater-Dimensional
IPM
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Onkyo dr l 50 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Onkyo dr l 50 in the language / languages: English as an attachment in your email.

The manual is 4,93 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info