492696
25
Zoom out
Zoom in
Previous page
1/64
Next page
25
Getting connected
(The 75/300 ohm antenna adapter is not
included with the U.S., Canadian, and Euro-
pean models.)
The 75/300 ohm antenna adapter can be
used to connect an FM antenna with 300
ohm at twin-core cable, or to connect an
FM antenna with a 75 ohm coaxial cable
with no connector attached.
Connecting 300 ohm flat twin-core
cable
1. Undo the two adapter screws, wrap the
bare wires around the screws, and then
retighten the screws, as shown.
2. Plug the 75/300 ohm adapter into the
CR-N1’s FM 75 connector.
Connecting 75 ohm coaxial cable
1. Using a small screwdriver or your
fingernails, push the tabs outwards and
remove the adapter’s cover, as shown.
2. Move the wire inside the adapter from
position A to position B, as shown.
3. Prepare the end of the 75 ohm coaxial
cable and place it in the adapter, as
shown.
4. Push the center conductor between the
lugs as shown (1), and use a pair of
pliers to clamp the braided wire section
of the cable to the adapter (2).
Make sure that the braided wires are not
shorting to the center conductor.
Using the 75/300 ohm FM
antenna adapter
Outdoor
antenna
Indoor
antenna
300 ohm flat
twin-core cable
Position B
Position A
Wire
1
2
6
mm
3
mm
6
mm
15 mm
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Onkyo CR-N1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Onkyo CR-N1 in the language / languages: English as an attachment in your email.

The manual is 2,63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info