63329
13
Zoom out
Zoom in
Previous page
1/32
Next page
13
Connecting Your Speakers
Before you connect your speakers, read the following:
Disconnect the power cord from the wall outlet.
Read the instructions supplied with your speakers.
•Pay close attention to speaker wiring polarity. Connect
positive (+) terminals only to positive (+) terminals, and
negative (–) terminals only to negative (–) terminals. If
you get them the wrong way around, the sound will be out
of phase and will sound odd.
If you’re connecting two sets of speakers (i.e., speaker set
A
and
speaker set B), the minimum impedance for each
speaker is 8
. If you’re connecting only one set of speak-
ers (i.e., speaker set A
or
speaker set B), the minimum
impedance for each speaker is 4
. Don’t connect speak-
ers with a lower impedance.
Unnecessarily long, or very thin speaker cables may
affect the sound quality and should be avoided.
Be careful not to short the positive
and negative connections. Doing so
may damage your CR-L5.
Don’t connect more than one cable to
each speaker terminal. Doing so may
damage your CR-L5.
If you want to connect a single speaker instead of a pair
of speakers, don’t connect it to both the left and right
speaker terminals.
You can use two sets of speakers with your CR-L5: speaker
set A and speaker set B.
Speaker set A
consists of front left and right speakers and a
subwoofer and should be installed in your main listening
room.
Speaker set B
consists of front left and right speakers and
can be installed in another room, such as a dining room or
kitchen.
1
Strip 15 mm (5/8") of
insulation from the
ends of the speaker
cables, and twist the
bare wires tightly, as
shown.
2
Unscrew the terminal.
3
Fully insert the wire.
4
Screw the terminal tight.
The following illustration shows how you should connect your speakers.
R
L
R
L
15 mm (5/8")
CD RECEIVER
MODEL NO. CR
-
L
5
R
L
R
L
A OR B
:
4 OHMS MIN.
/ SPEAKER
A
+
B
:
8 OHMS MIN.
/ SPEAKER
SPEAKERS
A SPEAKERS
B
REMOTE
CONTROL
PREOUT
R
L
R
L
TV/ LINE TAPE CDR
FM
75
ANTENNA
COAXIAL
OPTICAL
AUDIO
ANALOG
OUT OUT
SUB
WOOFER
IN IN IN
AUDIO
OUTPUT
DIGITAL
AM
Front-
left
speaker
Front-
right
speaker
Front-
left
speaker
Front-
right
speaker
Active
sub-
woofer
Speakers Set A
Speakers Set B
The SUBWOOFER PRE OUT should be
connected to the input on your active
subwoofer. If your subwoofer doesn’t have an
amp built-in, you’ll need to use an external
amp. See the manual supplied with your
subwoofer for more information.
CR-L5_E.book Page 13 Monday, May 19, 2003 4:05 PM
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Onkyo CR-L5 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Onkyo CR-L5 in the language / languages: English as an attachment in your email.

The manual is 1,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Onkyo CR-L5

Onkyo CR-L5 User Manual - German, Dutch, Swedish - 96 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info