670167
12
Zoom out
Zoom in
Previous page
1/14
Next page
In “STANDBY OFF” mode, press AL.SET button to turn off the alarm function.
disappears on the LCD Display).
ADJUST VOLUME
Press VOL.+ button to increase the volume during “STANDBY ON” mode
Press VOL. button to decrease the volume. “STANDBY OFF”
RADIO OPERATION
1. Press the STANDBY Button to switch on the unit.
2. Press the FUNCTION Button to the RADIO Function.
3. How to use the buttons for radio
i. Manual Tuning
Touch the SKIP+ / SKIP- button to search for desired frequency. Higher frequency can be selected by
touching the SKIP+ button while Lower frequency can be selected by touching SKIP- button
ii Automatic Tuning
a) Touch & hold the SKIP+ / SKIP- button until the display frequency starts run OR long press the SKIP
button to activate Automatic Tuning.
b) When a station of sufficient strength has been found Tuning will stop or you can stop the automatic
tuning by pressing SKIP+ / SKIP- button.
4. To turn off the radio, Press the STANDBY button.
PRESET TUNING
1. Select your desired station according to the normal tuning procedure.
2. Press the MEMORY button on the remote, “P-01” will appear and flash on the display, Then use M+
or M- button on the remote, or touch the PRESET button on the unit to change the number where
the station will be stored. (P01 to P20)
3. Store the current frequency by pressing MEMORY button on the remote again when you get the
desired number.
4. Repeat the same procedure to set other desired frequencies into Memory No.1 to No.20
Note: The unit can be preset up to 20 stations.
MEMORY RECALL
Recall the stored frequencies by pressing M+ or M- BUTTON on the remote, or touch the PRESET button on
the unit to select 1 to 20 stations as desired
NOTE: As stored frequencies can only be stored for long time with the power supplying. The station you
stored will be lost and can not be recalled in case that you cut off the power.
HANDING A COMPACT DISC
Always protect a disc against scratches, soil, dust and etc. If a disc is treated with reasonable care,
wiping off the disc with a soft cloth should be the only maintenance needed to retain its excellent
sound reproduction. Discs should be retained in their original case during periods of non-use.
Handle a disc only by its edges, Do not touch the surface or rainbow-colored side of the disc
Handle a disc as shown in the illustrations in this section
Use a soft cloth to wipe a disc clean. Do not use benzene, thinner, or other chemical cleaners to
clean the disc as damage may result. A disc should always be wiped in a straight line from its center
to its edge. Never wipe a disc in a circular motion.
Do not expose a disc to direct sunlight, high humidity, or high temperatures for extended periods of
time. Do not place the Disc on other equipment or near any heat source.
Dust on the pickup lens can lead to erratic operation and interruption of the sound during play. To
clean the pickup lens, open the disc compartment and blow the dust off . Using a camera lens
blower(available at most camera stores)
Note: Do not touch the surface of the lens. Do not allow any liquids on the inside of the product.
To clean the CD player cabinet, use a soft and damp cloth to wire off the exterior surface.
Never use benzol, benzene, or other strong chemical cleaners, as these could damage the finish.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for OneConcept V-14 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of OneConcept V-14 in the language / languages: English, German as an attachment in your email.

The manual is 0,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info