122554

One for All urc 8060 kameleon Manual

9
Zoom out
Zoom in
Previous page
1/128
Next page
8 WWW.ONEFORALL.COM
Learning (direct)
(How to copy functions from your original working remote onto the KAMELEON 6)
The KAMELEON 6 comes with a complete library of pre-programmed codes. After you have set up the KAMELEON 6 for your device, you may find that
there are one or more keys that you had on the original remote control, which do not have a place on the KAMELEON 6 keypad.
The KAMELEON 6 offers a special Learning feature that allows you to copy almost any function from your original remote control onto the keypad of the
KAMELEON 6.
The custom keys (I – IV) have been especially provided for this feature. If you need to learn more than four functions per mode (max. approximately 50
functions), you need to place the function on another key or on a shifted key.
Before you start:
- Make sure your original remote is working correctly.
- Make sure neither your KAMELEON 6, nor your original remote control is pointing at your device.
Example: To copy the “mono/stereo” function from your original TV remote control onto the ”IV”-key of your KAMELEON 6.
1. Place the KAMELEON 6 and your original remote control on a flat surface. Make sure the ends which you normally
point at your device are facing each other. Point the original remote to the front left side of the KAMELEON 6
(see picture below). Keep the remotes at a distance of 2 to 5 cm (0.8 to 2 inches).
2. Press and hold down the MAGIC key (for about 3 seconds) until the rabbit comes out of the hat.
3. Press 9 7 5. The bottom part of the animated IR Indicator will blink twice.
4. Press the device key (Example: TV key) on the KAMELEON 6 remote to select the mode to which you want to copy the learned
function.
5. Press the key (Example: IV key) on the KAMELEON 6 remote where you want to place the learned function. The IR Indicator will
show “incoming IR” three times and then the display will switch off.
6. Press and hold the key that you want to copy (Example: mono/stereo key on your original remote control). The display switches
back on and you will see two blinks to indicate successful learning operation.
7. If you want to copy other functions within the same mode, simply repeat steps 5 and 6 pressing the next key you want to copy by
learning. If your want to copy another function in a different mode, simply continue with step 4 followed by steps 5 and 6.
8. To exit the learning mode, Press and hold down the MAGIC key (for about 3 seconds) until
the bottom part of IR Indicator blinks four times.
- As soon as the display switches off in step 5 you need to press the key (in this example: the ”mono/stereo” key) on your original remote within 5
seconds. If no key is pressed while in
learning mode, the remote will return to user mode after 30 seconds.
- During learning, keys such as (TV) text, (TV) menu etc. will not change screen when pressed.
- If you learn a function on a key, the original KAMELEON 6 function automatically becomes shifted. Press the MAGIC key then the key to access it
(this excludes the POWER, Channel and Volume keys). If you learned on a digit key, access the original function by pressing magic twice and then
the digit.
- If you want to learn a function on a key that is not in the main screen, use the SCROLL key to change the screen.
- The learning feature is mode specific. Therefore you can place one learned function per mode on the same key.
- The KAMELEON 6 can learn approximately 50 functions.
- You can replace a learned function by placing another learned function on top.
- Please make sure not to use the learning procedure when in direct sunlight or under incandescent lights.
- Make sure you are using new batteries before following the instructions above.
- Upon changing the batteries, your learned functions will be retained.
(mono/stereo)
(IV)
IR receiver
Learning Feature
Camelion 20-09-2002 19:09 Pagina 8
… 9 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for One for All urc 8060 kameleon at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of One for All urc 8060 kameleon in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 6,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of One for All urc 8060 kameleon

One for All urc 8060 kameleon User Manual - English - 31 pages

One for All urc 8060 kameleon User Manual - Dutch - 31 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info