WWW.ONEFORALL.COM 11
Device Sleeptimer
If your television has a "Sleeptimer" function built in, you can access this
function with your ONE FOR ALL remote. To do so:
1 Make sure your television is switched on (not in standby).
2 Press the device key (TV).
3 Point the ONE FOR ALL at your television and press and release
MAGIC then press POWER. You should see the Sleeptimer activate
on your TV screen.
To increase the timer, simply press POWER again (within 5 seconds)
until the timer gets to the desired time.
To deactivate the Sleeptimer, repeat steps 1-3 above. During step 3,
continue pressing POWER (within 5 seconds) until the timer indicates zero
minutes.
ONE FOR ALL Sleeptimer
If your device does not have a sleeptimer function built-in, you can still
install the ONE FOR ALL Sleeptimer function.
Installing the ONE FOR ALL Sleeptimer:
1 Press the device key of the device you want to use the sleeptimer on
(this is only available for TV).
2 Press and hold MAGIC until the red light blinks twice.
3 Press 9 7 0. The red light will blink twice again.
Now your ONE FOR ALL 3 is setup to use the ONE FOR ALL Sleeptimer on
the device you selected in the setup above.
To activate the ONE FOR ALL Sleeptimer:
It is possible to set the ONE FOR ALL Sleeptimer for 15, 30, 45 or 60 minu-
tes. To do this, first make sure your TV is switched on.
4 Press the device mode key (TV).
5 Press and release the MAGIC key and then press POWER. The red
light will blink once to indicate the timer is activated for 15 minutes.
6 To increase the timer, simply press the POWER key again (this must
be done within 5 seconds). The red light will blink twice indicating
the timer is set for 30 minutes (2x15).
7 You can press the POWER to a maximum of four times. This will set
the timer to 60 minutes (indicated by 4 blinks).
Once you have set the timer to the desired time, set your ONE FOR ALL
remote down, pointing it at your device. When the programmed amount
of time has elapsed, the ONE FOR ALL 3 will send the command for
POWER, thereby turning off your device.
Important note: Depending on how you used the sleeptimer function on
your original remote, you might need to access the sleeptimer of your televi-
sion in a different way (through menu for example).
Important notes:
- The red light on the ONE FOR ALL 3 will blink every 15 seconds indicating
that the remote is in sleeptimer mode.
- To deactivate the timer, simply press any key on the ONE FOR ALL 3
remote.
- Once the ONE FOR ALL Sleeptimer has been installed it is not necessary to
repeat steps 1-3 above every time you wish to activate the timer. Simply
repeat steps 4-7.
- To uninstall the ONE FOR ALL Sleeptimer back to device sleeptimer, repeat
steps 1-3 above and the red light will blink four times.
- Remember to place the remote so it is pointing to your device when the
timer is activated.
- The ONE FOR ALL Sleeptimer can only be set-up for one device at a time.
