Manual Omron C 802 - CompAIR Basic (page 2 of 2) (English)

504866

Zoom out

Zoom in

1/2

Technical data

Product Description: Compressor Nebulizer

Model: NE-C802 (NE-C802-E)

Rating (AC adapter): 100-240V ~ 50/60Hz 15VA

Rating (Compressor

Nebulizer):

0.6A

Operating Temperature/

Humidity:

+10°C to +40°C / 30% to 85%RH

Storage and Transport

Temperature/Humidity/

Air Pressure:

-20°C to +60°C / 10% to 95%RH /

700 - 1060hPa

Weight: Approx. 190g (compressor only)

Dimensions: Approx. 85 (W) × 43 (H) ×115 (D) mm

(compressor only)

Contents:

Compressor, Nebulizer Kit, Air Tube (PVC,

100cm), Mouthpiece, Nosepiece, Adult Mask

(PVC), Child Mask (PVC), 5 pcs Spare Air

Filters, AC Adapter, Storage Bag, Instruction

Manual, Warranty Card.

Classification: Class ll equipment, Type BF applied part

= Class ll

equipment

= Type BF

applied part

Read the instruction

manual carefully

= No operation

= Power on

Technical data for the OMRON NE-C802 Compressor with the Nebulizer kit:

Particle Size: **MMAD Approx. 3m

MMAD = Mass Median Aerodynamic Diameter

Medication Tank Capacity: 10ml maximum

Appropriate Medication

Quantities:

2ml minimum - 10ml maximum

Sound: *Less than 45dB

Nebulization Rate: *Approx. 0.25ml/min (by weight loss)

Aerosol Output: **0.56ml (2ml, 1%NaF)

Aerosol Output Rate: **0.07ml/min (2ml, 1%NaF)

Result of cascade impactor measurements for particle size**

100

1 10 1000.1

Cumulative % particle mass of sodium fluoride undersize

Cumulative Undersize%

Particle Size (m)

Individual

Mean

Measured by OMRON HEALTHCARE Co., Ltd. Measured with saline at ambient

temperature of 23°C and humidity of 40%. It may vary with the type of medication.

Independently measured by Prof. Dr. Hiroshi Takano, Department of Chemical

Engineering and Materials Science, Faculty of Science and Engineering, Doshisha

University, Kyoto, Japan, according to EN 13544-1:2007+A1:2009.

Notes:

• Subject to technical modification without prior notice.

• This OMRON product is produced under the strict quality system of OMRON

HEALTHCARE Co., Ltd., Japan.

• The device may not work if the temperature and voltage conditions are different to

those defined in the specifications.

• The device fulfils the provisions of the EC directive 93/42/EEC (Medical Device

Directive) and the European Standard EN13544-1:2007+A1:2009, Respiratory

therapy equipment - Part1: Nebulizing systems and their components.

• Performance may vary with drugs such as suspensions or high viscosity. See drug

supplier’s data sheet for further details.

• See website of OMRON HEALTHCARE EUROPE to update technical information.

URL: www.omron-healthcare.com

Removing condensation from the air tube

If there is moisture or liquid remaining in the air tube, be sure to follow the

procedure below to remove any moisture from within the air tube.

1) Make sure that the air tube is connected to the air connector on the

compressor.

2) Remove the air tube from the nebulizer kit.

3) Turn on the compressor and pump air through the air tube to expel the

moisture.

Changing the air filter

If the air filter has changed colour, or has been used on average for more

than 60 days, replace it with a new one.

1. Pull the air filter cover off the compressor.

2. Change the air filter.

3. Put the air filter cover back in place.

Notes:

• Use only OMRON air filters designed for this device. Do not operate without air filter.

• Do not attempt to wash or clean the air filter. If the air filter becomes wet, replace it.

Damp air filters can cause blockages.

• There is no front or back orientation for the air filters.

• Check that air filters are clean and free of dust before inserting them.

• Do not boil the air filter cover.

Cleaning and disinfecting

Cleaning

Clean the parts after each use to remove residual medication. This will avoid

inefficient nebulization or infection.

Firstly, make sure that the power plug unplugged from the power outlet.

■

Nebulizer Kit (Inhalation top, Accessory Adapter, Medication tank),

Mask (PVC), Mouthpiece, Nosepiece

Wash them in warm water and mild detergent. Rinse them thoroughly with

clean hot tap water and allow to air dry in a clean place.

Note: Nebulizer kit should be replaced after using for one year. Replace ONLY with

nebulizer kit designed for NE-C802.

■

Compressor, Air Tube

Wipe clean with a soft cloth moistened with water or mild detergent.

■

Vaporizer Head

Wash it with running water.

Disinfecting

Disinfect the parts once a week. If the parts are heavily stained, replace

them with new ones.

Use one of the following methods:

To select the method, refer to the table below.

A. Use a commercially available disinfectant. Follow the instructions

provided by the disinfectant manufacturer.

1) Submerge the parts in the disinfectant for the specified period.

2) Rinse them with clean hot tap water and allow to air dry in a clean place.

Note: Never clean with benzene, thinner or a flammable chemical.

B. Parts may be boiled between 15 to 20 minutes.

After boiling, carefully remove the parts, shake

off excess water and allow to air dry in a clean

environment.

Note: Do not boil Air tube, Mask (PVC), Air filter and Air filter

cover.

Caution: Handling the Vaporizer Head

• Always wash the vaporizer head after each use.

• Do not use a brush or pin to clean the vaporizer head.

• When disinfecting the parts by boiling, be sure to boil them in plenty of water.

• Do not boil vaporizer head together with objects other than applicable nebulizer

accessories.

Use the table below as a guideline to select a method for disinfecting.

O: applicable ×: not applicable

Parts

Mouthpiece

Nosepiece

Nebulizer Kit

Air Filter

Air Filter Cover

Adult Mask (PVC)

Child Mask (PVC)

Air Tube

(PVC, 100cm)

Adult Mask (SEBS)

(optional)

Child Mask (SEBS)

(optional)

Materials

(Vaporizer Head: PC)

Polyester

ABS

Mask: PVC

(Phthalate free)

Band: Rubber

(non-latex)

PVC

(Phthalate free)

Mask: SEBS

Band: Rubber

(non-latex)

Adapter: PP

Boiling O O O × × × × O

Alcohol

OOO×O O × O

Disinfecting

ethanol

Sodium

hypochlorite

OOO×O O × O

Milton*

(0.1%)

Quaternary

ammonium

OOO×O O × O

Osvan*

(0.1%)

Chlorhexidine

OOO×O O × O

Hibitane*

(0.5%)

Amphoteric

Surfactant

OOO×O O × O

Tego*

(0.2%)

an example of commercially available disinfectant.

How to use

1. Make sure that the power switch is in the off ( ) position.

2. Connect the AC adapter to the compressor and plug the power plug into

a power outlet.

3. Remove the inhalation top together with

the accessory adapter and vaporizer

head from the medication tank.

4. Add the correct amount of prescribed

medication to the medication tank.

Reattach the vaporizer head to the

medication tank.

5. Put the inhalation top and accessory

adapter back inside the medication tank.

6. Attach the mask, mouthpiece or

nosepiece to the nebulizer kit tightly.

Note:

Make sure an arrow mark on the nebulizer

kit is facing toward the patient. Otherwise,

medication may be sprayed on patient’s skin

or clothes.

7. Attach the air tube.

Push the air tube plugs firmly

into the air tube connectors.

8. Hold the nebulizer kit as

indicated on the right.

Follow the instructions of your

doctor or respiratory therapist.

Exhale as normal through

mouthpiece, mask or through

the nose.

Caution:

Do not tilt the nebulizer kit at an

angle of greater than 45 degrees

in all directions. Medication may

flow into the mouth or it may result

in not nebulizing effectively.

9. Press the power switch to the on ( ) position. As the compressor

starts, nebulization begins and aerosol is generated.

Inhale the medication.

10. When treatment is complete, turn the power off. Unplug the AC adapter

from the power outlet and disconnect it from the compressor.

Note:

Securely hold and press the power plug

down to disconnect the AC adapter.

Caution:

Do not pull the power cord. Damage

may be caused.

Troubleshooting

Check the following if the device should fail during operation.

Problem Cause Remedy

Nothing happens when the

power switch is pressed.

Is the AC adapter connected

correctly to a power outlet and

the compressor?

Check that the AC adapter is

connected to a power outlet and

the compressor. Unplug then

reinsert the plug if necessary.

No nebulization or low

nebulization rate, when the

power is on.

Is there medication in the

medication tank?

Add the correct amount of

medication to the medication tank.

Is there too much/little

medication in the medication

tank?

Is the vaporizer head missing

or not assembled correctly?

Attach the vaporizer head

correctly.

Is the nebulizer kit assembled

correctly?

Assemble the nebulizer kit

correctly.

Is the nozzle blocked? Make sure that the nozzle is free

of blockages.

Is the nebulizer kit tilted at a

sharp angle?

Make sure that the nebulizer kit is

not tilted at an angle of more than

45 degrees.

Is the air tube connected

correctly?

Make sure that the air tube

is correctly connected to the

compressor and nebulizer kit.

Is the air tube folded or

damaged?

Make sure that the air tube does

not contain kinks.

Is the air tube blocked? Make sure that the air tube is free

of blockages.

Is the air filter dirty? Replace the air filter with a new

one.

The compressor is

abnormally loud.

Is the air filter cover attached

correctly?

Attach the air filter cover correctly.

The compressor is very hot. Is the compressor covered?

Do not cover the compressor with

any type of cover during use.

Note:

If the suggested remedy does not solve the problem, do not try to repair the device

- no parts of the device are user serviceable. Return the device to an authorized

OMRON retail outlet or distributor.

Clicks

Arrow

Right angle

45°45°

Compressor

Power plug

NE-C802-E_A_M EN.indd 2NE-C802-E_A_M EN.indd 2 23/08/2012 12:12:2423/08/2012 12:12:24

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Omron C 802 - CompAIR Basic in the language / languages: English as an attachment in your email.

The manual is 1,45 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Omron C 802 - CompAIR Basic Manual

Product: