576317
33
Zoom out
Zoom in
Previous page
1/42
Next page
PAS_TOP_SERIES.DOC
33/42
Installation of the TV-pin (only for stands)
Attach an appropriate TV-pin to the top end of the stand and fasten it with the handle at the side.
Suitable TV-pin: EUROLITE TV-35 TV-pin for speakers, No. 60000735
Installation of the speaker-system
Caution: The loads have to be installed in a balanced way.
Caution: The carrying capacity of the stand or speaker stand must never be exceeded!
Install the speaker-system via the flange on the speaker stand or via the TV-pin on the stand.
Make sure that the maximum lifting height of the tube is never exceeded.
Lifted telescopic tubes always have to be secured with a secondary securing!
Installation on a wall-mounting
The speaker-system may only be installed on a wall-mounting if the original speaker-system is equipped with
an appropriate flange.
Suitable wall-mountings:
Wall-mounting for Speakers w. flange No. 60004610
Wall-mounting XY for Speakers w. flange No. 60004620
When installed on a wall-mounting, the speaker-system must always be secured with a safety-rope.
Before attaching the speaker-system, make sure that the
installation area can hold a minimum point load of 10 times the
installation's weight (e.g. 13 kg weight - 130 kg point load).
The durability of the installation depends very much on the
material used at the installation area (building material) such as
wood, concrete, gas concrete, brick etc. This is why the fixing
material must be chosen to suit the wall material. Always ask a
specialist for the correct plug/screw combination indicating the
maximum load and the building material.
The wall-mounting must always be installed via all fixation holes.
Do only use appropriate screws and make sure that the screws
are properly connected with the ground.
Procedure:
Step 1: On the wall-mounting, there are the holes for the installation.
Step 2: Hold the wall-mounting onto the location where it is to be installed.
Step 3: Mark the boreholes with a pen or a suitable tool.
Step 4: Drill the holes.
Step 5: Hold the wall-mounting in the desired position and tighten the screws.
Step 6: Insert the eye-bolts into the threaded holes. The eye-bolts must be tightened until stop position,
hand-tight and without any tools.
Step 7: Install the speaker-system on the wall-mounting.
Step 8: Insert the quick links of the safety-ropes in the eye-bolts of the speaker-system. Pull the safety-
ropes through the wall-mounting’s safety eyelet. Insert the end in the quick link and tighten the
safety screw.
33


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Omnitronic PAS-208 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Omnitronic PAS-208 in the language / languages: English, German as an attachment in your email.

The manual is 5,99 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info