651590
5
Zoom out
Zoom in
Previous page
1/16
Next page
Instructions for Machine Transport
NOTE: Refrigeration equipment must remain upright to avoid damage to
the compressor In order to prevent the oil contained in the compressor
from flowing into the cooling circuit, it is necessary to always ship, carry,
store and handle this Granita machine in an upright position, following
the instructions located on the packaging. Never ship, carry, store or
handle unit on its side.
Installation
1.) Cut banding straps from box and lift the box off the machine (see fig. 1).
2.) Positioning the machine
The machine must be well ventilated. Leave an 8” (20 cm) clearance on the sides
and back of the machine to allow proper ventilation. Installation of the machine
near a heat source should be avoided. Some heat sources you should avoid locating
this unit too close to are ovens, coffee machines, cold or frozen beverage dispensers
or ice machines (equipment with compressors that expel hot air through its vents. An
ambient temperature between 59°F (15°C) and 77°F (25°C) is recommended.
Connection to Main Power Supply
• The electrical safety of this Granita machine can only be achieved if the ma-
chine is properly connected to an appropriate grounded receptacle that is in com-
pliance with current national safety standards. Therefore, the manufacturer cannot
be held responsible for damage and/or injury caused by failure to connect the unit
to an appropriate power source.
• For a safe and correct installation, connect the unit to a dedicated outlet.
• Do not alter the cord or plug in any way.
• The entire length of the power supply cord must not, in any way, be com
pressed (bent or bunched together) nor may extension cords be used.
• Do not obstruct the ventilation and heat dispersion grill vents on the side and
rear panels of the unit. An insufficient ventilation process may reduce the efficiency
of the machine, causing it to function inadequately, and cause serious damage to
the machine. A minimum of eight inches (20cm) clearance is necessary on each side
and behind the unit.
WARNING: THIS UNIT MUST BE PROPERLY ELECTRICALLY GROUNDED TO AVOID POSSIBLE
FATAL ELECTRICAL SHOCK OR SERIOUS INJURY TO THE OPERATOR. THE POWER CORD IS
PROVIDED WITH A THREE PRONG GROUNDED PLUG. IF A THREE-HOLE GROUNDED
ELECTRICAL OUTLET IS NOT AVAILABLE, USE AN APPROVED METHOD TO GROUND THE
UNIT. DO NOT USE EXTENSION CORDS WITH THIS UNIT. DO NOT “GANG” TOGETHER
WITH OTHER ELECTRICAL DEVICES ON THE SAME OUTLET.
4
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Omega OFS30 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Omega OFS30 in the language / languages: English as an attachment in your email.

The manual is 3,94 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info