538569
27
Zoom out
Zoom in
Previous page
1/31
Next page
EN 27
EN
Q3: How to handle the flash after use?
A3: After using the flash, remove the batteries at once and seal it again
with the battery cap and then rinse it in pure water. After use in salt
water, you should immerse the flash for an extended period of time
in pure water. Operate the switches when it is in clean tap water to
remove any salt from their shafts. After rinsing, remove moisture
with a dry cloth free of salt, and dry the flash in the shade. Never
use hot air from a hair dryer or other appliances to dry the flash,
and never place it in direct sunlight to dry, as this could deform,
discolor, damage or deteriorates the flash and O-ring.
The inner side of the flash should be wiped with a soft, lint-free
cloth.
Remove the O-ring, wipe off the attached foreign matter such as
salt, sand and dirt, also clean the grooves in which O-ring has
been fitted and the surface in contact with the O-ring (battery cap
side), and dry all of them.
When removing an O-ring from the groove, do not use a sharp
object to avoid damaging the O-ring and causing leaks. Be
always sure to use the provided remover for removing the O-
ring.
Q4: What are the causes for entry of water?
A4: The main causes for the entry of water are shown below. Please
check them most carefully.
1 Forgetting to install the O-ring
2 The O-ring is partly or completely outside the groove
3 Damage, deterioration, or deformation of the O-ring
4 Sand, fibers, hair or other foreign matter on the O-ring
5 Sand, fibers, hair or other foreign matter on the O-ring groove or the
O-ring contact surface
6 Throwing the flash from a boat into the water, jumping with the flash
into the water, or other sudden application of strong forces onto the
flash. When entering the water, hand the flash over gently or avoid
impacts in other ways.
UFL-1_EN.book Page 27 Tuesday, February 20, 2007 6:09 PM
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Olympus UFL-1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Olympus UFL-1 in the language / languages: English as an attachment in your email.

The manual is 1,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Olympus UFL-1

Olympus UFL-1 User Manual - German - 31 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info