776853
50
Zoom out
Zoom in
Previous page
1/53
Next page
50 51
Q&A
QThe FC-1 cannot be turned on.
AIt cannot be turned on in the following cases.
When the connector(s) for the unused flash (either the Ring Flash or Twin Flash) is not
capped.
When both the Ring Flash and Twin Flash are connected.
QIs multi-flash shooting possible in the TTL AUTO mode?
ANo, it is not possible.
QWhy does the flash get hot after successive firing?
AThe batteries generate heat when flash firing is repeated successively. In this case, use the
flash at intervals until the light-emitting section and batteries cool down.
QWhy can’t I mount the FC-1 on the camera?
AIt cannot be mounted if the lock pin is in the out position. If this is the case, turn the lock ring all
the way in the opposite direction to [fl LOCK] until it stops. Once the lock pin is in the in
position, you can mount the FC-1 on the camera (page 14).
QWhy doesn’t the control mode change when I press the MODE button?
AWhen the Macro Flash System is connected to certain types of communication-capable cam-
era, the flash control mode may only be controlled from the camera.
QWhat is the recommended white balance setting for the camera when using the flash?
AThe auto white balance mode is recommended. If you use the manual white balance mode,
set the color temperature to 5500K. Note that the color temperature varies depending on the
flash shooting conditions.
QWhen the Olympus E-1 Four Thirds System digital camera enters the sleep mode, the FC-1’s
control panel display turns off. Is this normal?
AYe s, it is normal. When the E-1 enters the sleep mode, so does the FC-1. When the camera
wakes up, so does the FC-1.
QDoes the FC-1 also turn off when the Olympus E-1 digital camera is turned off?
AWhen the Olympus E-1 Four Thirds System digital camera is turned off, the FC-1 enters the
sleep mode. When the E-1 is turned on again, the FC-1 also turns on. When you want to turn
off the FC-1, turn off the FC-1 before turning off the E-1. In addition, when connected to a
camera without communication capability, the FC-1 enters the sleep mode if it is not operated
for about 60 minutes.
MAIN SPECIFICATIONS
Macro Flash Controller FC-1
Model Number : FS-FC1
Type : External flash controller for digital still camera
Light-emitting device
:Ring Flash RF-11 or Twin Flash TF-22, exchangeable.
Auto power OFF :
Interlocks with the auto power OFF operation of a camera with communication capability.
Illuminator : Automatic firing at low intensity, possible only when a camera with com-
munication capability is connected.
Standard effective distance
:
0.2 to 3 m (0.7 to 9.9 ft) (Variable depending on the camera and lens in use.)
Power supply : AA (R6) alkaline dry cell batteries (LR6) x 4,
AA (R6) Ni-Cd batteries x 4,
AA (R6) Ni-Mh batteries x 4,
AA (R6) Ni-Mn batteries (ZR6) x 4,
AA (R6) lithium batteries (FR6) x 4 or
3 V lithium battery pack (Olympus LB-01) x 2
External power supply
:
Flash High Voltage Set SHV-1 (optional)
Dimensions : 78(W) x 141(H) x 119(D) mm (3.1 x 5.6 x 4.7 in.) (excluding protrusions)
Weight : 320 g (11.3 oz) (excluding batteries)
Operating environment
:Temperature: 0 to 40°C (32 to 104°F).
Humidity: No more than 80% (without condensation).
Ring Flash RF-11
Model Number : FS-RF11
Type : External flash for digital still camera
Guide numbers : TTL AUTO : 11
MANUAL : 0.7 to 11
Firing angle : 8
Flash emission period
:Approx. 1/560 sec.
Flash emission count
:Approx. 250 times (using the LR6-type AA (R6) alkaline dry cell batter-
ies) or approx. 420 times (using the LB-01 lithium battery packs). (Vari-
able depending on shooting conditions)
Recharge time : Approx. 4 seconds (using the AA (R6) alkaline manganese batteries) or
approx. 4 seconds times (using the LB-01 lithium battery packs).
Flash modes : TTL AUTO and MANUAL
Illuminator : 4 lamps built in.
Lens mount : Bayonet
Cable length : Approx. 100 mm (3.9 in)
Dimensions : 120(W) x 135.5(H) x 24(D) mm (4.7 x 5.3 x 0.9 in.) (excluding cable)
Weight : 145 g (5.1 oz)
Operating environment
:Temperature: 0 to 40°C (32 to 104°F).
Humidity : No more than 80% (without condensation).
(From full flash activation to
lighting of Charge lamp)
50


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Olympus RF-11 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Olympus RF-11 in the language / languages: English as an attachment in your email.

The manual is 4.51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info