776853
5
Zoom out
Zoom in
Previous page
1/53
Next page
4 5
Note on the cameras used with the Macro Flash System
The functions available from the Macro Flash System are limited with certain digital cameras. For details, please check
the Olympus website (http://www.olympusamerica.com/E1).
Before reading this manual
The information in this manual may be subject to change without notice.
This manual has been compiled as carefully as possible. However, if you have any questions or wish to report an error
or omission, please contact Olympus.
Duplication of this manual in part or in whole without permission of Olympus is prohibited except for personal use.
Reproduction of the contents of this manual without permission of Olympus is strictly prohibited.
Olympus will not assume any liability for damages, loss of profit or claims from any third party incurred due to improper
use of this product.
Olympus will not assume any liability for damages and loss of profit related to the loss of image data due to a failure of
this product, servicing by a third party not designated by Olympus, or any other reason.
Note that the quality of pictures shot with this product differs from the quality of pictures taken with ordinary film-based
cameras.
Trademark information
All brand names and product names mentioned in this manual are the trademarks or registered trademarks of their respec-
tive owners.
HANDLING PRECAUTIONS
The Macro Flash System is composed of precision electronic parts. Absolutely avoid using or storing the
Macro Flash System in the following places, as this may result in malfunction or failure.
• Under direct sunlight, on a beach, etc.
• Anywhere exposed to high temperature and humidity or rapid fluctuations in temperature and humidity.
• Any place exposed to excessive sand, dust or dirt.
• Near a fire.
• Near an air conditioner or air humidifier.
• Any place exposed to water or moisture.
• Any place subject to vibrations.
• Inside an automobile.
Do not apply a strong vibration or shock to the Macro Flash System by dropping it or hitting it against
something.
When the Macro Flash System has not been used for a long period, mold or moss may form. This can cause
a malfunction. To prevent this, it is recommended to check the operations before using the Macro Flash
System after a long period of storage.
Do not touch the electric contacts of the Macro Flash System to prevent malfunction.
To prevent overheating and deterioration of the light-emitting section, do not continue full activation more than
40 times in a row. After firing the flash 40 times successively, do not use the flash for at least 10 minutes to
allow the light-emitting section to cool down.
BATTERY PRECAUTIONS
Use only the specified batteries.
• AA (R6) alkaline dry cell batteries (LR6 type) ..................... x 4
• AA (R6) Ni-Cd batteries ...................................................... x 4
• AA (R6) Ni-Mh batteries ..................................................... x 4
• AA (R6) Ni-Mn batteries (ZR6 type) ................................... x 4
• AA (R6) lithium batteries (FR6 type) ................................... x 4
• Lithium battery packs (CR-V3 type) (Olympus LB-01) ....... x 2
* AA (R6) manganese batteries cannot be used.
Be sure to observe the following points. Otherwise, battery fluid leak, overheating, fire ignition and/or bursting
may result.
• Do not mix old and new batteries, recharged and discharged batteries, batteries of different capacities, or
batteries of different types or brands.
• Do not attempt to recharge non-rechargeable batteries such as alkaline batteries.
• Do not load or use the batteries with the +/– polarity reversed. If the batteries do not fit smoothly in the battery
compartment, do not force them.
• Never use a battery if its outer coating (insulation) has been partially or entirely peeled off. Otherwise, leak-
age, overheating or explosion may result.
• Some brand-new batteries may also have their outer coating (insulation) peeled off completely or partially.
Never use these batteries.
Do not use the following kinds of batteries.
All rechargeable batteries must be recharged using the specified battery charger, simultaneously and com-
pletely. Be sure to read the battery and battery charger instruction manual.
Improper use of batteries may result in fluid leak, heat generation and/or damage. Sweat and oil smudges
may cause battery contact failure. To prevent this, remove any stain completely with a dry cloth and insert the
batteries by observing the +/– polarity.
In general, battery performance will be temporarily reduced as the ambient temperature drops. When using
batteries in a cold place, keep them warm by keeping the Macro Flash System in cold protection gear or
clothing.
If battery fluid gets on your skin or clothes, it may irritate your skin. Immediately rinse your skin or clothes with
clean water.
If battery fluid comes in contact with your eyes, blindness may result. Rinse your eyes with clean water without
rubbing them and see a doctor immediately.
Do not apply a strong shock to a battery or throw it.
When traveling, it is a good idea to carry spare batteries with you. In some countries, it may be difficult to
obtain certain batteries.
Do not immerse batteries in water or moisten the terminals at its both ends.
If the +/– terminals of a battery are stained with sweat or oil smudges, contact failure may result.
Clean the terminals well with a dry cloth before using the batteries.
Do not throw a battery in fire or heat it.
When disposing of batteries, be sure to follow local regulations.
When disposing of a rechargeable battery, insulate the +/– terminals with pieces of tape and take them to your
nearest rechargeable battery recycling center.
Outer coating (insu-
lation) is peeling or
has peeled off.
The negative end is
slightly swollen and
is not covered by the
coating (insulation).
The negative end is
flat (whether or not a
part of the negative
pole is covered by
the coating).
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Olympus RF-11 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Olympus RF-11 in the language / languages: English as an attachment in your email.

The manual is 4.51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info