538526
122
Zoom out
Zoom in
Previous page
1/149
Next page
122
EN
Using separately sold accessories
11
3
Adjust the settings for each group in the LV super control panel.
250250 F5.6
0.0
0.0
P
3838
A Mode
TTL
M
Off
+5.0
TTL +3.0
1/8
LO
1
Ch
Flash intensity value
Group
• Select the ash control
mode and adjust the ash
intensity separately for
each group. For MANUAL,
select the ash intensity.
Normal ash/Super FP ash
• Switch between normal
ash and Super FP ash.
Communication light level
• Set the communication
light level to [HI], [MID],
or [LO].
Channel
• Set the communication
channel to the same
channel used on the ash.
Flash intensityFlash control
mode
Adjust settings for the camera
ash unit.
4
Press the ash switch to pop up the internal ash.
• After con rming that the built-in and remote ash units have charged, take a test shot.
Wireless ash control range
Position the wireless ash units with
their remote sensors facing the camera.
The following illustration shows the
approximate ranges at which the ash
units can be positioned. The actual control
range varies with local conditions.
7m
5m
100°100°
50°
50°
50°
50°
60°
60°
30°
30°
30°
30°
# Cautions
We recommend using a single group of up to three remote ash units.
• Remote ash units cannot be used for second curtain slow synchronization or anti-shock
exposures longer than 4 seconds.
If the subject is too close to the camera, the control ashes emitted by the supplied ash
may affect exposure (this effect can be reduced by reducing the output of the internal
ash by, for example, using a diffuser).
The upper limit of ash synchronization timing is 1/160 sec. when using the ash in
remote control mode.
Other external ash units
Note the following when using a third-party ash unit mounted on the camera hot shoe:
• Using obsolete ash units that apply currents of more than about 24 V to the camera hot
shoe X-contact will damage the camera.
• Connecting ash units with signal contacts that do not conform to Olympus speci cations
may damage the camera.
Set the Shooting mode to M, set the shutter speed to a value no higher than ash
synchronous speed, and set ISO sensitivity to a setting other than [AUTO].
Flash control can only be performed by manually setting the ash to the ISO sensitivity
and aperture values selected with the camera. Flash brightness can be adjusted by
adjusting either ISO sensitivity or aperture.
• Use a ash with an angle of illumination suited to the lens. Angle of illumination is usually
expressed using 35-mm format equivalent focal lengths.
122


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Olympus E-P5 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Olympus E-P5 in the language / languages: English as an attachment in your email.

The manual is 3,81 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Olympus E-P5

Olympus E-P5 User Manual - German - 149 pages

Olympus E-P5 User Manual - Dutch - 148 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info