568997
15
Zoom out
Zoom in
Previous page
1/60
Next page
15
G
Putting the transmitter unit into operation
The transmitter unit can be powered either by the mains power supply via the power adapter plug [21] or by
4 rechargeable or standard AAA batteries.
Inserting the batteries in the transmitter unit
The batteries for the transmitter unit are not included with the equipment supplied.
Loosen the screw holding the battery compartment cover [24]
using an appropriate screwdriver and remove the battery
compartment cover [23].
Insert the batteries (4 x AAA) in the battery compartment, paying
attention to correct polarity.
Replace the battery compartment cover [23] and tighten the screw
in the battery compartment cover [24] with an appropriate screwdriver.
The transmitter can be operated with 4 "AAA" batteries (not contained in the material supplied) or
with rechargeable batteries of the same type. Please remember that the batteries cannot be re
charged directly in the device. A commercially available charging unit is required.
Connecting the transmitter unit via the power adapter plug
Connect the power adapter plug to the power adapter socket [21] on the transmitter unit and a prop
erly installed mains power outlet. Ჿ The transmitter unit is switched on automatically.
Mounting the base on the transmitter unit
Insert and tighten the screw in the thread [22] in the base on the rear side of the transmitter unit.
Switching the transmitter unit on/off
The transmitter unit continues to transmit even when the receiver unit is switched off. The signals
can be received by other devices.
5 sec. [19] Ჿ Transmitter unit is switched on.
5 sec.
[19] Ჿ Transmitter unit is switched off.
Operating indicator on transmitter unit
Operating indicator [17] lights up. Ჿ Transmitter unit is switched on.
Registering/Deregistering transmitter units
5 sec. [4] Ჿ Operating indicator [17] flashes quickly.
5 sec.
[20] Ჿ Operating indicator [17] flashes slowly.
After about one minute, the operating indicator [17] lights up continuously - the transmitter unit is
registered on the receiver unit.
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Olympia MBF 7010 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Olympia MBF 7010 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 0,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info