Manual Olsberg Tipas Plus Compact (page 14 of 36) (English, German, Dutch, French)

707625

Zoom out

Zoom in

1/36

Regulations to be observed

● Local and building law regulations

● The stove must be installed by a professional and

connected to the chimney. The specic national reg-

ulations for safe installation of the connector must be

complied with. The connecting piece used must pos-

sess an opening for cleaning.

● The stove must be regularly checked by a

professional.

● The stove has national technical approval from the

Deutsches Institut für Bautechnik (DIBt) (German

Institute for Civil Engineering) for room-air independ-

ent operation.

Due to its general technical approval, the stove can

be used simultaneously with an approved ventila-

tion system without additional safety device.

Equipped with a self-closing combustion chamber

door, the stove is approved to be connected to multi-

ue chimneys provided that it operates with a roomair

dependent combustion-air supply.

Room-air independent operation requires that the ex-

haust gases of the replace be discharged through a

singleue chimney or the exhaust duct of a singleue

air-exhaust chimney. Exhaust gases may also be dis-

charged into multiue exhaust gas systems if all con-

nected replaces are part of the same utilisation unit/

action range of the ventilation system. Individual differ-

ences can be discussed with your district master chim-

ney sweep.

Chimney design

The chimney design is according to DIN EN 13384-1

and 2 or to the specic national regulations. The chim-

ney must comply with the temperature class T400.

Necessary data

Closed operation

with billet wood / wood briquettes / lignite briquettes:

● Nominal thermal output ................. 4,0 / 4,0 / 4,0 kW

● Waste air mass ow rate ........... 4,4 / 4,16 / 3,75 g/s

● Waste air temperature at

connection duct ........................... 358 / 369 / 327 °C

● Minimum delivery pressure at

nominal thermal output ...................... 12 / 12 / 12 Pa

Combustion air supply

The stove can be operated conventionally, dependent

on the ambient air as well as independent of the am-

bient air.

It must be guaranteed that there is enough combustion

air available for the stove. For the proper function of the

stove, a necessary combustion air volume current of

15,6 m³/h must be considered.

Ambient air independent

combustion air connection

By an ambient air independent operating mode, the

combustion air must be added from outside through a

leak-proof line or through a supply duct in the chimney.

Thus, speak with your district chimney sweep master.

Due to energy saving reasons, the combustion air in-

let should be able to be blocked if the stove is not being

operated. This can occur through a shut-off valve in the

combustion air line or through the air slide valves on

the stove. If a shut-off valve is used, this must be clear-

ly identied with CLOSED/OPEN.

Through the shutoff, it is avoided that heat is removed

from the set-up room through the constant circulation

of cold combustion air and cold combustion air lines

may lead to an increased formation of condensation.

Attention:

The combustion air line may not be closed during

operation!

In order to feed the combustion air to the stove exter-

nally via a pipe instead of from the room in which it is in-

stalled, it is possible to screw a Ø 125 mm combustion

air pipe to the back of the stove or at the bottom. If the

combustion air pipe installed is longer than 3 m, calcu-

lations will have to be carried out to verify an adequate

supply of combustion air. At extremely low outdoor tem-

peratures, condensation can occur on the combustion

air duct. For this reason it must be insulated with a suit-

able insulating material. Observe the rules of the oven

and air heating construction craft.

Use the Olsberg combustion air pipes with sealing lip.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Olsberg Tipas Plus Compact in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,19 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Olsberg Tipas Plus Compact Manual

Product: